Bil, MITSUBISHI, LANCER (CY, Z0), 2011, CZ4A, SNGFZR8, ABS, ASC, ASTC, WSS A.S.C.
Bremse system - ABS/ASC/ASTC/WSS A.S.C. - 0
Identifikation
Identificere : 80 10
ECU origin: 04
Supplier number: 22
ECU ID: 80
Diagnose version: 10
Hardware version nummer: 07 01
Softwareversion: 07 01 00
Dele nummer: 4670B231
Software nummer: 4670B23100
VIN no (original): JMBSNCY2A8U006320
Class: NC
Model: ASX
Type: GA6W
Model year: 2011
Stel nr.: JMBXJGA6WBZ428337
Calibration ID: --
Calibration verification number (CVN): --
Fejlkoder
C1707: Implausible coding data
C121C: Torque request signal rejection
U0401: Engine (CAN message)
Controls
Clear DTC
Levende Data
Venstre forhjulshastighedsføler: 655.35 km/h
Højre forhjulshastighedsføler: 291.88 km/h
Venstre baghjuls hastighedsføler: 0.66 km/h
Højre baghjulshastighedsføler: 8.03 km/h
Left front wheel cylinder pressure: 1.27 bar
Right front wheel cylinder pressure: 0.30 bar
Left rear wheel cylinder pressure: 0.15 bar
Right rear wheel cylinder pressure: 1.70 bar
Steering angle: 0.92 °
Yaw rate sensor: 10.03 °/sec
Master cylinder pressure: 38.73 bar
Lateral acceleration sensor: 0.170 G
Acceleration sensor: -0.06 G
Motor Hastighed: 127.5 Omdr.
Motordrejningsmoment: 25.5 N·m
Accelerator pedal position sensor: 63.5 %
Allow ASC torque request: Ikke tilladt
Actual gear: D
Target gear: P
Right front wheel cylinder pressure offset: 0.0144 bar
Left rear wheel cylinder pressure offset: 0.0000 bar
Right rear wheel cylinder pressure offset: 8.5463 bar
Acceleration sensor offset: -0.0164 G
Yaw rate sensor offset: 6.3684 °/sec
Master cylinder pressure offset: 0.0819 bar
Lateral acceleration sensor offset: 0.0221 G
Left front wheel cylinder pressure offset: 20.4794 bar
Ignition switch: Sluk
Power supply voltage: 13.3 V
SAS ok flag: SAS fail & no comp
Køretøjs hastighed : 1.3 km/h
ASC/TCL off switch (input): Tænd
Brake switch (input): -
Power supply voltage (input): 2.3 V
Ignition switch (input): Tænd
Parking brake switch: Tænd
ASC/TCL off switch: Tænd
Brake switch: Tænd
Bremsetrykføler: Ikke trykket
Emission test mode: Tænd
Brake fluid pressure switch:
Udgangs test
Controls
Left front wheel ABS drive
Right front wheel ABS drive
Left rear wheel ABS drive
Right rear wheel ABS drive
Left front wheel TCL drive
Right front wheel TCL drive
Left rear wheel TCL drive
Right rear wheel TCL drive
Engine TCL drive
Muligheder
Controls
Emission gas mode
Sensor calibration
Cut valve pressure learning
Inlet valve pressure learning