Car, MERCEDES, X 290 AMG, 290.661 Mercedes-AMG GT 53 4MATIC+ Coupe, Front signal acquisition and actuation module (DSAM)
Body control module - Front signal acquisition and actuation module (DSAM) - 0
Identification
Diagnostic version: 00 04 1A
Boot software number: 0.0.0
Hardware version: 0.0.0
Software version: --
Software version 1: --
Software version 2: --
Supplier: --
Hardware part number:
Software part number (customer): --
Software part number (code): --
Software part number (data): --
Serial number: --
VIN no:
DTC
P010000: Mass or volume air flow (MAF) sensor 1/A - electrical fault
Controls
Clear DTC
Data stream
Circuit 30 (1): 0.0 V
Circuit 30 (2): 0.0 V
Circuit 15: 0.0 V
Outside air temperature sensor analog input: 0.00 mV
Brake fluid level switch: 0.00 V
Right front brake wear sensor: Not active
Coolant level switch: 0.00 V
Windshield washer fluid level indicator switch: 0.00 V
Supply voltage of dedicated short-range communications control unit: Off
Supply voltage of weight sensing system (WSS) control unit: Off
Fanfare high tone: Off
Fanfare low tone: Off
Duct 1 of exterior lights switch: Left parking light
Duct 2 of exterior lights switch: Fault
Duct 3 of exterior lights switch: ---
Hazard warning system button illumination: Off
Right high beam: Off
Left high beam: Off
Right rear turn signal lamp: Off
Left rear turn signal lamp: Off
Left rear side-marker lamp: Off
Right rear side-marker lamp: Off
Footwell light: Off
Outside temperature: -40.00 °C
Brake fluid pressure (calculated): 0.00 V
Brake fluid level indicator lamp: Off
Brake linings indicator lamp: Off
Coolant level indicator lamp: Off
Washer fluid level indicator lamp: Off
Left engine hood contact switch: --
Right engine hood contact switch: Undefined
Windshield wiper stage: --
Outside air temperature internally calculated: 0.00 V
Input signals: outside air temperature: Ok
Status of input signal 'Brake fluid level switch': Ok
Right front brake wear sensor: Ok
Right rear brake wear sensor: Ok
Coolant level switch (calculated): 0.00 V
Windshield washer fluid level indicator switch (calculated): 0.00 V
Washer fluid level indicator lamp (temperature is too low): Off
Terminal 58d input value: 0.00 V
Status of input signal 'Hazard warning system button': Not operated
Right front brake wear sensor: Off
No-load current shutoff relay: Off
Crash signal: Off
Right engine hood contact switch: Undefined
Windshield washer pump: Off
Spray nozzle hose heater: Off
Engine start request by ECO start/stop function: Not active
Engine stop inhibit - diagnosis: Not active
Engine stop inhibit - on-board electrical system: Not active
Engine stop inhibit - battery: Not active
Engine stop inhibit - ambient conditions: Not active
Engine stop inhibit - LIN error: Not active
Frequency counter 'Activation of component 'Fanfare horn'' (<1s): 0
Frequency counter 'Activation of component 'Fanfare horn'' (1s-5s): 0
Frequency counter 'Activation of component 'Fanfare horn'' (5s-10s): 0
Frequency counter 'Activation of component 'Fanfare horn'' (>10s): --
Production mode: Not active
Transport mode: Not active
Test of no-load current: Not performed
Odometer: 0 km
Remaining service life: 0 days
Were you prompted to change the battery?: No
Charge level: 0.00 %
Electrical charge throughput: 0.00 Ah
Electrical charge throughput: -- Ah
Speed threshold: -- km/h
Parking position: Off
Crash signal: Off
Circuit 30g voltage: 0.00 V
Circuit 15 relay: Undefined
Fanfare high tone: 0.00 A
Fanfare low tone: 0.00 A
Supply voltage of weight sensing system (WSS) control unit: 0.00 A
Crash signal: Close
Brake fluid level switch: Closed
Coolant level switch: Closed
Windshield washer fluid level indicator switch: Closed
Diagnostic trace memory: 00 00 00 00 00 00 00 00 00 00 00 00
Actuators test
Controls
Exterior lighting
Windshield washer system pump
Headlamp cleaning system pump (rear window)
Reserve relay
Spray nozzle hose heater
Circuit 15 relay
Fanfare horns
External ligts demo mode
Windshield wiper
Footwell light
Confirmation of battery change
Deep dischange protection
Configuration
Controls
Variant coding WWC
Activate SAR data storage
Closure switch model
ILC HW approvals