Car, MERCEDES, Sprinter 906, 906.637, 2013-, Stationary heater (STH)
Climate control - Stationary heater (STH) - 0
Identification
MB number for hardware: 9064467821
Diagnostic version: 3.1
Hardware number: 07.30
Software number: 07.34
Supplier: Borg
Diagnostic version: 03 01
DTC
900D: Auxiliary heater does not start
9017: Blower motor incorrect speed
Event 902C: Fuel tank level is too low
Controls
Clear DTC
Data stream
Coolant temperature: 45 °C
Overheating sensor: 64 °C
Flame sensor: -40 °C
Red LED: Off
Yellow LED: On
Pushbutton heating: Open
Pushbutton auxiliary heating: Open
Status: two-way radio receiver (OPTIONAL): No signal
Learning process: radio remote control (OPTIONAL): Not learned
Heat output level: Off
Flame detection: Yes
Crash signal: Not received
STH fuel metering pump: 0 Hz
Blower motor: 0 V
Glow pin: 144 %
Terminal 30: -- V
STH heater unit:
Signal via CAN bus: ambient temperature: 76 °C
CAN bus signal: circulation pump: Off
CAN bus signal: front end blower (stage 1): Off
Current parameterization in control module EZS: Heater booster
Fuel tank level: 0 L
Actuators test
Controls
Switch on stationary heater (normal mode)
Switch on stationary heater (test mode)
Combustion air blower
Stationary heater metering pump
Glow pin
Coolant circulation pump
Blower motor relay
LED 'Instant heat'
LED 'Memory function'