Car, MERCEDES, SMART 450, 450.005, Electronic stability program (ESP)
Brake system - Electronic stability program (ESP) - 0
Identification
MB number for hardware: 0034462040
Diagnostic version: 128.0
Hardware number: 00.00
Software number: 06.40
Supplier: Bosch
Diagnostic version: 80 00
VIN no (original): WDB12345678909876
VIN no: WDB12345678901234
DTC
C1560: Function 'Roller dynamometer mode' active
Controls
Clear DTC
Data stream
Right front wheel speed sensor: 1 km/h
Left front wheel speed sensor: 2 km/h
Right rear wheel speed sensor: 3 km/h
Left rear wheel speed sensor: 4 km/h
Lateral acceleration sensor: -767.40 m/s²
Steering wheel angle sensor: 244 °
Yaw rate sensor: -3469 °/sec
Brake pressure sensor: 4 bar
Stop light switch: Not operated
Brake pedal switch: Operated
Handbrake switch: Not operated
Brake fluid level: Ok
Valve relay: Off
Left front inlet solenoid valve: Off
Left front outlet solenoid valve: Off
Right front inlet solenoid valve: Off
Right front outlet solenoid valve: Off
Left rear inlet solenoid valve: Off
Left rear outlet solenoid valve: Off
Right rear inlet solenoid valve: Off
Right rear outlet solenoid valve: Off
Front axle switchover solenoid valve: Off
Rear axle switchover solenoid valve: Off
High-pressure switching valve for front axle: Off
High-pressure switching valve for rear axle: Off
Steering wheel angle sensor: Initialized
Calibration of steering wheel angle sensor: Not calibrated
Roller dynamometer mode (switch on ESP): Active
Dynamic sensitivity test of component yaw rate sensor: Not active
Dynamic sensitivity test of component lateral acceleration sensor: Not active
Offset test of component yaw rate sensor: Not active
Pressure sensor test: Not active
VIN no (original): WDB12345678909876
VIN no: WDB12345678901234
Utility
Controls
Steering wheel angle sensor calibration