Car, MERCEDES, S 221, 221.186 S 500 (S 550 US) 4MATIC L, 2009-, Front signal acquisition and actuation module (DSAM)
Body control module - Front signal acquisition and actuation module (DSAM) - 0
Identification
MB number for hardware: 2215408462
Diagnostic version: 0.10
Hardware number: 06.45
Software number: 07.05
Supplier: Temic
Diagnostic version: 00 0A
DTC
9070: Right standing and parking lamp - circuit open or short
Event 9102: Windshield washer fluid level indicator switch - circuit open
Controls
Clear DTC
Data stream
CAN message from control module EZS: ignition key position: Ignition key not inserted
Terminal 15R relay circuit: On
Terminal 15R relay circuit: On
Left standing and parking lamp: 17 %
Right standing and parking lamp: 34 %
Left low beam output: 51 %
Right low beam output: 68 %
Left high beam output: 85 %
Right high beam output: 102 %
Left front turn signal output: 119 %
Right front turn signal output: 136 %
Storage compartment illumination: 170 %
Illumination switch: 187 %
Load output of steering wheel heater: On
Heating water circulation pump: On
Steering column forward/back motor (FORWARD): On
Steering column forward/back motor (BACK): On
Steering column raise/lower motor (UP): On
Steering column raise/lower motor (DOWN): On
Windshield washer pump: On
Headlamp washer pump: On
Terminal 15: -- V
Terminal 30: -- V
Ambient temperature display temperature sensor: -- °C
Current monitoring at output heating steering wheel: --
Current monitoring at output heating water circulation pump: --
Brake fluid level: --
Washer fluid level: --
Coolant level status: --
Current monitoring at output windshield washer pump: --
Current monitoring at output headlamp washer pump: --
Right front brake lining: Not Ok
Steering column forward/back motor: Normalized
Steering column raise/lower motor: Normalized
Steering column forward/back motor: 4369
Steering column raise/lower motor: 13107
Serial number: 00 01 38 22
Left parking lamp: Not operated
Right parking lamp: Not operated
Automatic driving lamps: Not operated
Side lamp: Not operated
Driving lights: Not operated
Safety contact: Not operated
Fog light: Not operated
Rear fog light: Not operated
CAN message from control module UCP: exterior lamp switch (Initializing): Not active
Illumination switch: 33 %
S1s1 (HCS [SRA] switch): Operated
CAN message from control module OCP: light sensor (Tunnel): Not recognized
Day/night switchover: Day
CAN message from control module OCP: Rain/light sensor (Communication): Ok
Rain/light sensor: Not initialized
Rain sensor swirl detection: Not recognized
Wiper stage: Stage 0
Rain sensor status: Ok
S4s2 (Headlamp flasher and high beam switch): Not operated
CAN message from control module CGW: switch on component left front turn signal lamp: Not active
CAN message from control module CGW: switch on component right front turn signal light: Not active
CAN message from control module CGW: A40/9s3 (Hazard warning system button): Not operated
Steering column adjustment raise/lower, forward/back switch: Not operated
S4s4 (Windshield washer system switch): Not operated
Night view assist button: Not operated
S110s5 or S111s5 (pushbutton for fanfare horns): Not operated
CAN message from control module CGW: S16/13 (DIRECT SELECT gear selector switch): In park position
S4s5 (Wipe switch): Not operated
Vehicle model: Cabrio (A)
Driver seat position: Right-hand steering
National version: Rest of World
Light sensor: Not present
Rain sensor: Not present
Stationary heater: Present
Replacement light function: Not permitted
Configuration
Controls
Windscreen washer system heated
Automatic windshield wiper speed reduction when vehicle is stationary
A/C water valve