Car, MERCEDES, S 221, 221.122 S 320 CDI L, 2009-, Front signal acquisition and actuation module (DSAM)

Body control module - Front signal acquisition and actuation module (DSAM) - 0

Identification

MB number for hardware: 2215408462

Diagnostic version: 0.10

Hardware number: 06.45

Software number: 07.05

Supplier: Temic

Diagnostic version: 00 0A

DTC

9070: Right standing and parking lamp - circuit open or short

Event 9102: Windshield washer fluid level indicator switch - circuit open

Controls

Clear DTC

Data stream

CAN message from control module EZS: ignition key position: Ignition key not inserted

Terminal 15R relay circuit: On

Terminal 15R relay circuit: On

Left standing and parking lamp: 17 %

Right standing and parking lamp: 34 %

Left low beam output: 51 %

Right low beam output: 68 %

Left high beam output: 85 %

Right high beam output: 102 %

Left front turn signal output: 119 %

Right front turn signal output: 136 %

Storage compartment illumination: 170 %

Illumination switch: 187 %

Load output of steering wheel heater: On

Heating water circulation pump: On

Steering column forward/back motor (FORWARD): On

Steering column forward/back motor (BACK): On

Steering column raise/lower motor (UP): On

Steering column raise/lower motor (DOWN): On

Windshield washer pump: On

Headlamp washer pump: On

Terminal 15: -- V

Terminal 30: -- V

Ambient temperature display temperature sensor: -- °C

Current monitoring at output heating steering wheel: --

Current monitoring at output heating water circulation pump: --

Brake fluid level: --

Washer fluid level: --

Coolant level status: --

Current monitoring at output windshield washer pump: --

Current monitoring at output headlamp washer pump: --

Right front brake lining: Not Ok

Steering column forward/back motor: Normalized

Steering column raise/lower motor: Normalized

Steering column forward/back motor: 4369

Steering column raise/lower motor: 13107

Serial number: 00 01 38 22

Left parking lamp: Not operated

Right parking lamp: Not operated

Automatic driving lamps: Not operated

Side lamp: Not operated

Driving lights: Not operated

Safety contact: Not operated

Fog light: Not operated

Rear fog light: Not operated

CAN message from control module UCP: exterior lamp switch (Initializing): Not active

Illumination switch: 33 %

S1s1 (HCS [SRA] switch): Operated

CAN message from control module OCP: light sensor (Tunnel): Not recognized

Day/night switchover: Day

CAN message from control module OCP: Rain/light sensor (Communication): Ok

Rain/light sensor: Not initialized

Rain sensor swirl detection: Not recognized

Wiper stage: Stage 0

Rain sensor status: Ok

S4s2 (Headlamp flasher and high beam switch): Not operated

CAN message from control module CGW: switch on component left front turn signal lamp: Not active

CAN message from control module CGW: switch on component right front turn signal light: Not active

CAN message from control module CGW: A40/9s3 (Hazard warning system button): Not operated

Steering column adjustment raise/lower, forward/back switch: Not operated

S4s4 (Windshield washer system switch): Not operated

Night view assist button: Not operated

S110s5 or S111s5 (pushbutton for fanfare horns): Not operated

CAN message from control module CGW: S16/13 (DIRECT SELECT gear selector switch): In park position

S4s5 (Wipe switch): Not operated

Vehicle model: Cabrio (A)

Driver seat position: Right-hand steering

National version: Rest of World

Light sensor: Not present

Rain sensor: Not present

Stationary heater: Present

Replacement light function: Not permitted

Configuration

Controls

Windscreen washer system heated

Automatic windshield wiper speed reduction when vehicle is stationary

A/C water valve