Car, MERCEDES, R 251, 251.075 R 500 4MATIC, Electronic ignition switch (EIS)

Immobilizer - Electronic ignition switch (EIS) - 0

Identification

MB number for hardware: 1645451308

Diagnostic version: 0.8

Hardware number: 06.38

Software number: 06.38

Supplier: Marquardt

Diagnostic version: 00 08

DTC

Event 9008: No CAN message was received from intelligent servo module for DIRECT SELECT

Controls

Clear DTC

Data stream

Key inserted in control module EIS: Yes

Start and stop button 'Keyless Go' pressed: No

Key in position 'H0' (auxiliary contact): Yes

Output terminal 15C (CAN): On

Output 'Circuit 15R' (CAN): On

Output terminal 15 (CAN): On

Output terminal 15X (CAN): On

Output terminal 50 (CAN): On

Serial number: 11 FF 00 00 00 77 66 55

Power supply: 12.00 V

Key or key track last used: 3

Second last key or key track used: 1

Control module EIS is initialized: Yes

The transport protection of control module EZS is detached: Yes

Control module EIS is personalized: Yes

Control module EIS is activated: Yes

Version of control module EZS: Series

Key or key track 1: Enabled

Key or key track 1: Used

Key or key track 2: Enabled

Key or key track 2: Not used

Key or key track 3: Enabled

Key or key track 3: Used

Key or key track 4: Enabled

Key or key track 4: Used

Key or key track 5: Enabled

Key or key track 5: Used

Key or key track 6: Enabled

Key or key track 6: Used

Key or key track 7: Enabled

Key or key track 7: Used

Key or key track 8: Enabled

Key or key track 8: Used

EIS: turn enable issued: No

ME motor electronics: start enable: No

Intelligent servo module for DIRECT SELECT: start enable: No

Automatic transmission: start enable: No

VIN no: 12345678912345678

Key monitoring: Inactive

Key monitoring was active: Yes

Control module ISM is initialized: No

The transport protection of control module ISM is detached: No

Control module ISM is personalized: No

Control module ISM is activated: No

Kilometer reading (EIS): 72030 km

Driver door status: Opened

Utility

Controls

Edit VIN

Configuration

Controls

Edit configuration