PKW, MERCEDES, M 164, 164.121 ML 300 CDI 4MATIC, Electronic Stability Program (ESP)

Bremsanlage - Electronic Stability Program (ESP) - 0

Identifikation

MB Hardwarenummer: 2515451132

Diagnoseversion: 3.1

Hardwarenummer: 04.48

Softwarenummer: 04.48

Lieferant: Teves

Diagnoseversion: 03 01

Fehlercode

7266: ESP control module internal malfunction

5170: Steering wheel angle zero point variation

Controls

Fehlercode löschen

Ist-Werte

Spannung Klemme 87: 14 V

Brake wear indicator: Vorhanden

Raddrehzahlsensor vorn links: 1 km/h

Raddrehzahlsensor vorne rechts: 8 km/h

Raddrehzahlsensor hinten links: 16 km/h

Raddrehzahlsensor hinten rechts: 14 km/h

Motor: EIN

Bremslicht: AUS

ESP OFF switch: Not operated

Parking brake indicator switch: AUS

BAS release switch: AUS

BAS diaphragm travel sensor: 2 mm

ESP brake pressure sensor: 7.7 Bar

Geber für Lenkwinkel: 2.1 °

Steering wheel rotation speed: 2.2 °/sec

Geber für Querbeschleunigung: 0.8 g

Längsbeschleunigung: 7.7 g

Status 'Tire pressure loss warner': Active / No warnings found

Kilometer reading at warning no. 1: 582 km

Kilometer reading at warning no. 2: 1128 km

Kilometer reading at warning no. 3: 1674 km

Kilometer reading at reactivation no. 1: 2220 km

Kilometer reading at reactivation no. 2: 2766 km

Kilometer reading at reactivation no. 3: 3312 km

Kilometer reading at deactivation: 3858 km

Learning status: tire pressure loss warner: Aktiv

Motordrehzahl: 6144 UpM

Steering wheel angle value: 537.60 °

Motordrehmoment: 3072.1 N·m

Engine torque (STATIC): 1228.9 N·m

Raddrehzahlsensor vorn links: 6144.0 UpM

Raddrehzahlsensor vorne rechts: 537.0 UpM

Kickdown-Modus: Operated

DTR - Distronic: Vorhanden

Bremspedal-Schalter: Operated

Variable speed: Operated

Decelerate and set (Stage 2): Operated

Accelerate and set (Stage 2): Operated

Decelerate and set (Stage 1): Operated

Accelerate and set (Stage 1): Operated

Resume from memory: Operated

S40s4 (Off): Operated

Steering wheel angle sensor offset: 16.00

Dienst­programme

Controls

Steering wheel angle offset value reset

Konfiguration

Controls

Konfiguration ändern