PKW, MERCEDES, E 238, 238.480 E200 Cabriolet, Front signal acquisition and actuation module (DSAM)

Diagnoseversion: 00 04 1A

Boot software number: 0.0.0

Hardware-Version: 0.0.0

Softwareversion: --

Software version 1: --

Software version 2: --

Lieferant: --

Hardware-Teilenummer:

Software part number (customer): --

Software part number (code): --

Software part number (data): --

Seriennummer: --

FIN:

P010000: Mass or volume air flow (MAF) sensor 1/A - electrical fault

Fehlercode löschen

Stromkreis 30 (1): 0.0 V

Stromkreis 30 (2): 0.0 V

Stromkreis 15: 0.0 V

Outside air temperature sensor analog input: 0.00 mV

Schalter Bremsflüssigkeitsstand: 0.00 V

Right front brake wear sensor: Nicht aktiv

Schalter Kühlmittelstand: 0.00 V

Windshield washer fluid level indicator switch: 0.00 V

Supply voltage of dedicated short-range communications control unit: AUS

Supply voltage of weight sensing system (WSS) control unit: AUS

Fanfare high tone: AUS

Fanfare low tone: AUS

Duct 1 of exterior lights switch: Left parking light

Duct 2 of exterior lights switch: Fehler

Duct 3 of exterior lights switch: ---

Hazard warning system button illumination: AUS

Right high beam: AUS

Left high beam: AUS

Lampe für Blinklicht hinten rechts: AUS

Lampe für Blinklicht hinten links: AUS

Left rear side-marker lamp: AUS

Right rear side-marker lamp: AUS

Fußleuchte: AUS

Outside temperature: -40.00 °C

Bremsflüssigkeitsdruck (berechnet): 0.00 V

Brake fluid level indicator lamp: AUS

Brake linings indicator lamp: AUS

Coolant level indicator lamp: AUS

Washer fluid level indicator lamp: AUS

Left engine hood contact switch: --

Right engine hood contact switch: Unbestimmt

Windshield wiper stage: --

Outside air temperature internally calculated: 0.00 V

Input signals: outside air temperature: In Ordnung

Status of input signal 'Brake fluid level switch': In Ordnung

Right front brake wear sensor: In Ordnung

Right rear brake wear sensor: In Ordnung

Coolant level switch (calculated): 0.00 V

Windshield washer fluid level indicator switch (calculated): 0.00 V

Washer fluid level indicator lamp (temperature is too low): AUS

Terminal 58d input value: 0.00 V

Status of input signal 'Hazard warning system button': Not operated

Right front brake wear sensor: AUS

No-load current shutoff relay: AUS

Crash signal: AUS

Right engine hood contact switch: Unbestimmt

Scheibenwaschpumpe: AUS

Spray nozzle hose heater: AUS

Engine start request by ECO start/stop function: Nicht aktiv

Engine stop inhibit - diagnosis: Nicht aktiv

Engine stop inhibit - on-board electrical system: Nicht aktiv

Engine stop inhibit - battery: Nicht aktiv

Engine stop inhibit - ambient conditions: Nicht aktiv

Engine stop inhibit - LIN error: Nicht aktiv

Frequency counter 'Activation of component 'Fanfare horn'' (<1s): 0

Frequency counter 'Activation of component 'Fanfare horn'' (1s-5s): 0

Frequency counter 'Activation of component 'Fanfare horn'' (5s-10s): 0

Frequency counter 'Activation of component 'Fanfare horn'' (>10s): --

Production mode: Nicht aktiv

Transport mode: Nicht aktiv

Test of no-load current: Nicht durchgeführt

Kilometerzähler: 0 km

Remaining service life: 0 Tage

Were you prompted to change the battery?: Nein

Charge level: 0.00 %

Electrical charge throughput: 0.00 Ah

Electrical charge throughput: -- Ah

Drehzahlschwelle : -- km/h

Parking position: AUS

Crash signal: AUS

Stromkreis 30g Spannung: 0.00 V

Circuit 15 relay: Unbestimmt

Fanfare high tone: 0.00 A

Fanfare low tone: 0.00 A

Supply voltage of weight sensing system (WSS) control unit: 0.00 A

Crash signal: Schließen

Schalter Bremsflüssigkeitsstand: Geschlossen

Schalter Kühlmittelstand: Geschlossen

Windshield washer fluid level indicator switch: Geschlossen

Diagnostic trace memory: 00 00 00 00 00 00 00 00 00 00 00 00

Exterior lighting

Windshield washer system pump

Headlamp cleaning system pump (rear window)

Reserve relay

Spray nozzle hose heater

Circuit 15 relay

Fanfare horns

External ligts demo mode

Frontscheibenwischer

Fußraumbeleuchtung

Confirmation of battery change

Deep dischange protection

Variant coding WWC

Activate SAR data storage

Closure switch model

ILC HW approvals