Car, CHERY, EASTAR, MIKADO , ORIENTAL SON (B11FL, B11), AT DPO system (AT)
Transaxle - AT DPO system (AT) - 0
Identification
Part number: 82 00 99 12 28
Diagnostic ID: 04
Supplier number: 001
Hardware number: 82 00 69 50 35
Software number: 95 00
Edition calibration: 04 00
System calibration number: 9F 40
VIN no:
DTC
P0841: Auto gearbox internal pressure
P2753: EPDE short circuit
Controls
Clear DTC
Data stream
Gear engaged: 3 Lockup
Shift lock: Active
Gear lever position signal: Intermediate
Multifunction switch position: Vref sync cmd EVLU; Vref sync cmd EVM; S2; S3; S4; P-N; MFS sequential command +; MFS sequential command -
Oil pressure: 0.0 bar
Oil pressure reference: 0.0 bar
A/T turbine speed: 2719.7 rpm
Engine speed: 2720.0 rpm
Oil temperature: 35.0 °C
Manual mode: Not defined
Warning status in display: Not defined
Gear shifting mode: Unlock
Brake pedal switch normally open: 1 cutoff
Brake pedal switch normally closed: 1 cutoff
Vehicle speed sensor: 0.0 km/h
Engine torque (from CAN): -100.0 N·m
Coolant temperature signal: -50.0 °C
EVMTONin: 0.0
CAN engine torque excluding automatic transmission: -100.0
EVLUTONin: 34.0
Torque requested by driver: 33.5 %
Battery voltage: 8.50 V
Winter mode: Inactive
Transmission status: Neutral
Multifunction switch position: -
Gear selector: S2; S3; S4; P-N; MFS sequential command +; MFS sequential command -
Oil pressure: 4.2 bar
Oil temperature: -50.0 °C
Standard pedal position: 115.0
Brake pedal switch normally open: Close
Brake pedal switch normally closed: Close
Engine coolant temperature (CAN bus): 86.0 °C
Shift solenoid valve 5/E control: Yes
Shift solenoid valve 1/A control: Yes
Shift solenoid valve "F" control: Yes
Shift solenoid valve 2/B control: Yes
Shift solenoid valve 3/C control: Yes
Shift lock solenoid: Active
Shift solenoid valve 4/D control: Yes
Dynamic mode switch:
Default: Warning fault
Engine speed (CAN bus): 8160.0 rpm
Turbine speed: 2720.0 rpm
Target vehicle speed: 118.2 km/h
Actual turbine shaft speed: 10.7 rpm
Target vehicle speed: 98.7 km/h
Accelerator pedal position (CAN): 33.3
CAN signals: engine speed: 1188.6 rpm
Gear selected: Reverse
Actuators test
Controls
Shift solenoid valve 1/A
Shift solenoid valve 2/B
Shift solenoid valve 3/C
Shift solenoid valve 4/D
Shift solenoid valve 5/E
Shift solenoid valve 6/F
EPDE exchanger output solenoid valve
EVM pressure control solenoid valve output
EVLU lock up control solenoid valve output
SSVL shift lock solenoid valve output