Bil, CHERY, TIGGO 7 Pro (T1E), SQRF4J16 - Engine management system (ECM)
SQRF4J16 - Engine management system (ECM) - 0
Identifikation
Dele nummer: 131000162AA
Supplier code: 2AN
Supplier ECU hardware number: F01RB0DJ4U
Supplier ECU software number: F218D1A469
Application data identification: F218D1A468
Motortype: D4T20
Stel nr.:
Number of updates: 20200914
Fejlkoder
Controls
Clear DTC
Levende Data
GPF (Gasoline Particulate Filter) differential pressure sensor after-run phase static learning value - current value: -- hPa
GPF (Gasoline Particulate Filter) differential pressure sensor after-run phase static learning value - historical value: -- hPa
Coefficient used for CCF to calculate the ash: --
Fuel consumption for calculation of ash: -- L
Engine running time for calculation of ash: -- sek
Ash influence: --
Gasoline particulate filter (GPF) soot load simulated: --
Gasoline particulate filter (GPF) soot load measured: --
Motordrejningsmoment: 27.01 %
Trykføler til brændstoftank: -- hPa
Actual lambda value: -- V
Evaporative emission (EVAP) system, canister vent valve: --
Average value of voltage pressure sensor second purge line: -- V
Motordrejningsmoment: 27.01 %
Bilkonfiguration: DC8531323132323232323232323535353535353535353536
Køretøjets hastighed sensor: 34 km/h
Batteri spænding: 11.63 V
Outside air temperature: 51 °C
Idle speed actuator: 1320 Omdr.
Calculated coolant temperature at engine outlet: -32.25 °C
Target throttle position: 53.64 %
Coolant temperature at engine start: 17.25 °C
Model-based reference value for plausibility check of engine temperature signal: 39.00 °C
Electronic throttle control (ETC) throttle lower limit: 113.31 %
Gasspjældpositionsføler 1: 751.69 %
Gasspjældpositionsføler 2: 46.12 %
Motor Hastighed: 4238 Omdr.
Motor kølevæske temperatur føler: 51.75 °C
Intake air temperature sensor: 15.00 °C
Intake air temperature, raw value: 1.50 °C
Accelerator pedal position sensor: 28.13 %
Outside pressure sensor: 840.86 hPa
Doubled PWG potentiometer 2: 150.40 V
Absolute intake manifold pressure: 181.29 hPa
Gasspjældpositionsføler 1: 12.65 V
Gasspjældpositionsføler 2: 2.31 V
PWG potentiometer 1: 126.82 V
PWG potentiometer 2: 310.77 V
Clutch pedal: 87 times
Maximum torque at current speed: 7.08 %
Idle torque adaptation: 67.25 %
Lambda sonde / O2 sensor 2, bank 1: 169.48 V
O2 sensor 2 output: 0.32 V
Tændings vinkel: -93.0 °
Lambda sonde / O2 sensor 1, bank 1: 22.59 V
Target ignition angle: 90.00 °
Idle speed control target torque correction: 30.58 %
Vacuum pump relay: forbeholdt
Ladetrykføler: 182.70 hPa
Relief valve: Sluk
Water pump relay: Pull
Distance since check engine telltale on: 14162 km
Ambience valve switch: 60 %
Model-based substitute value for engine temperature signal in case of error: 63.00 °C
Engine running time since last engine start: 2163.6 sek
Voltage DK-Poti 1 at the NLP-position: 41.43 V
Brake light: forbeholdt
A/C request: forbeholdt
A/C medium voltage switch: forbeholdt
A/C high/low voltage switch: forbeholdt
Clutch switch: forbeholdt
Brake switch (input): Ikke aktiv
Clutch switch bottom: forbeholdt
Cooling fan high speed: forbeholdt
Cooling fan low speed: forbeholdt
Oil pump operating mode: Tænd
Indsugningsmanifoldtryk: 725.78 hPa
MAP føler: 90.73 V
Correction factor for air mass flow: 1.80
Target engine torque: 15.80 %
Relative air charge: 54.75 %
Relative air mass: 8.98 %
Conditions for disabling engine shutdown from vehicle start/stop system - drive chain status relay fault: Nej
Conditions for disabling engine shutdown from vehicle start/stop system - from engine: Nej
Conditions for disabling engine shutdown from vehicle start/stop system - from TCU: Nej
Conditions for disabling engine shutdown from vehicle start/stop system - from BCM: Nej
Conditions for disabling engine shutdown from vehicle start/stop system - high altitude: Nej
Conditions for disabling engine shutdown from vehicle start/stop system - in anti-slip status: Nej
Conditions for disabling engine shutdown from vehicle start/stop system - in the parking place: Nej
Conditions for disabling engine shutdown from vehicle start/stop system - front hood open: Nej
Conditions for disabling engine shutdown from vehicle start/stop system - driver not seated: Nej
Conditions for disabling engine shutdown from vehicle start/stop system - conditions for disabling start/stop from electronic braking system (EBS): Nej
Conditions for disabling engine shutdown from vehicle start/stop system - brake vacuum level too low: Nej
Conditions for disabling engine shutdown from vehicle start/stop system - conditions for disabling Start/Stop from A/C: Nej
Conditions for disabling engine shutdown from vehicle start/stop system - starter thermal protection: Nej
Conditions for disabling engine shutdown from vehicle start/stop system - neutral gear, lower clutch switch diagnosis not completed: Nej
Conditions for disabling engine shutdown from vehicle start/stop system - upper clutch switch diagnosis not completed: Nej
Gear transmission ratio: 3.9
Vehicle speed output: 271 km/h
Conditions for disabling engine start from vehicle start/stop system - monitoring layer determined that the driver is not seated: Nej
Conditions for disabling engine start from vehicle start/stop system - driver not seated: Nej
Conditions for disabling engine start from vehicle start/stop system - front hood open: Nej
Conditions for disabling engine start from vehicle start/stop system - door open: Nej
Conditions for disabling engine start from vehicle start/stop system - seat belt not fastened: Nej
Conditions for disabling engine start from vehicle start/stop system - neutral gear, lower clutch switch diagnosis not completed or a fault occurred: Nej
Conditions for disabling engine start from vehicle start/stop system - upper clutch switch diagnosis not completed or a fault occurred: Nej
Conditions for disabling engine start from vehicle start/stop system - drive chain status relay diagnosis not completed or a fault occurred: Nej
Conditions for disabling engine start from vehicle start/stop system - door open or seat belt not fastened: Ja
Intake air temperature before throttle valve: 6.75 °C
Electric water pump pulse-width modulation (PWM) duty cycle output value: 57.03 %
Throttle potentiometer 1 voltage signal at mechanical low dead center: 1.43 V
Long term fuel trim bank 1 additive: 219.05 %
O2 sensor 2 heater resistance, filtered: 37162 Ohm
Fuel system status: Open loop, conditions for closed loop not yet satisfied
Indsprøjtnings tid B1: 237.82 ms
Oil-film short term compensation quantity at transient operation: 68.750
Kortsigtet brændstoffinjustering: 0.939
Long term fuel trim bank 1, multiplication: 0.143
Injection quantity: 1626.80 %
Misfire cylinder 1: 4641
Total number of misfire: 38023
Oil-film long term compensation quantity at transient operation: 103.91
Misfire cylinder 2: 1889
Misfire cylinder 3: 29268
Misfire cylinder 4: 69
Canister purge duty cycle: 38.88 %
Canister purge flow: 25.35 kg/h
Intake manifold length switching request: Tænd
Intake valve opens related to LWOT angle: -237.84
Intake camshaft position target: 200.63 °
VVT exhaust target angle (bank 1): -- °
Intake camshaft duty cycle: 45.39 %
Exhaust camshaft duty cycle: 28.16 %
Exhaust gas temperature sensor 1, bank 1: 449.29 °C
Ignition timing cylinder 4: 51.75 °
Knock retard angle cylinder 1: 15.00 °
Knock retard angle cylinder 2: 61.50 °
Knock retard angle cylinder 3: 84.75 °
Knock signal cylinder 1: 2.67 V
Knock signal cylinder 2: 2.65 V
Knock signal cylinder 3: 2.35 V
Knock signal cylinder 4: 1.08 V
Engine torque monitoring: 51.56 %
Engine speed maximum area of misfire: 4640 Omdr.
Misfire range, minimum rpm: 5920 Omdr.
Calculated actual torque in function monitoring: 15.23 %
Temperature sensor for engine temperature management: 40
Nominal maximum indicated engine torque limitation: 840 N·m
Fuel flow: 0.005 L/s
Misfire range, maximum load: 26.95 %
Misfire range, minimum load: 31.64 %
Longitudinal acceleration sensor: -24.09 m/s²
Battery voltage (ADC): 145.40 V
Gear engaged: forbeholdt
Lambda sonde /O2 sensor Sted / location: 84
OBD requirements for which this vehicle is designed: 137
Oil temperature: 155.94 °C