Car, KIA, General, MOHAVE , BORREGO (HM), 2017, G 3.8 MPI LAMBDA, Engine suspension control (ECS)
Continuous damping control - Engine suspension control (ECS) - 0
Identification
Vehicle name:
System name:
Software version number:
Hardware version number:
DTC
Controls
Clear DTC
Data stream
Battery voltage: 5.35 V
Ignition supply voltage: 20.08 V
Supply voltage for sensor: 10.04 V
Height sensor rear left: 5.02 V
Height sensor rear right: 5.02 V
Pressure sensor voltage: 5.02 V
Temperature sensor voltage: 5.02 V
Trunk switch: Not supported
Up switch: Not supported
Down switch: Not supported
Air spring control valve - Rear right: Not supported
Air spring control valve - Rear left: Not supported
Exhaust valve: Not supported
Valve relay: Not supported
Compressor relay: Not supported
Vehicle speed: 255 km/h
Engine running status: Not supported
Height deviation from normal level - Rear left: -153.4 mm
Height deviation from normal level - Rear right: 455.4 mm
Pressure sensor: 11.9 bar
Temperature sensor: 215 °C
Actuators test
Controls
Filling RL Valve Using Reservoir Tank
Filling RL Valve Using Compressor
Venting RL Valve
Filling RR Valve Using Reservoir Tank
Filling RR Valve Using Compressor
Venting RR Valve
Filling Reservoir Tank Using Compressor
Venting Reservoir Tank
Filling RL RR Valve Using Compressor
Filling RL RR Valve Using Reservoir Tank
Venting RL and RR Valve
Utility
Controls
Height sensor calibration (Reset)
RL_Air_Filling
RL_Air_Venting
RR_Air_Filling
RR_Air_Venting
Halt System Control
AIR FILLING SETUP
Height sensor de-calibration
Height Sensor Mount Angle