Car, KIA, Korea, LOTZE (MG), 2007, G 2.0 DOHC, G 2.0 DOHC - Engine (ENGINE)

G 2.0 DOHC - Engine (ENGINE) - 0

Identification

Software version bootloader:

ECU software version number: --

Calibration ID:

DTC

Controls

Clear DTC

Data stream

A/C switch: On

Variant coding: A/T

A/C status: On

Check engine telltale: On

A/C compressor: On

Ignition switch: On

Fuel pump: On

Throttle closed position: On

Main relay: On

Throttle full open: On

Camshaft and crankshaft synchronization: On

Fuel cut-off: On

Cranking signal: On

Fuel system status: --

Knocking detection: --

Cranking signal: --

CVVT actuation status: --

O2 sensor 2, bank 1 operation: --

O2 sensor 1, bank 1 operation: --

Drive status: --

Canister purge state: --

Canister purge phase: --

Idle rpm control: --

Mass air flow sensor: 319.81 V

Mass air flow sensor: 6553.5 kg/h

Engine load: 1535.9 %

Throttle position sensor: 4.98 V

Throttle position PWM servo signal: 100.0 %

Adapted throttle position sensor: 20.4 °

Battery voltage: 17.37 V

Engine coolant temperature sensor: 143.2 °C

Engine coolant temperature sensor (model): -- °C

Intake air temperature sensor: -- °C

Evaporative emission (EVAP) system, canister purge valve: -- %

Injection time cylinder 1: -- ms

Injection time cylinder 2: -- ms

Injection time cylinder 3: -- ms

Injection time cylinder 4: -- ms

Torque request from TCU: 100.0 %

O2 sensor 1, bank 1 heating time: 2550 ms

O2 sensor 2, bank 1 heating time: 2550 ms

O2 sensor 1, bank 1: 1.330 V

O2 sensor 2, bank 1: 1.330 V

Target idle speed: 2550 rpm

Idle speed actuator: 100.0 %

idle speed actuator offset: 100.0 %

Engine speed: 16383.8 rpm

Engine oil temperature: -- °C

Ignition angle: -- °

Vehicle speed: -- km/h

Short term fuel trim bank 1: -0.0 %

Long term fuel trim (idle): -0.0 %

Long term fuel trim (part load): -0.0 %

Knock adaption cylinder 1: 0.0 °

Knock adaption cylinder 2: 0.0 °

Knock adaption cylinder 3: 0.0 °

Knock adaption cylinder 4: 0.0 °

CVVT adaption PWM: 50.0 %

A/C pressure: 510 psi

CVVT duty control status: -

Inlet CAM position: 155.6 °

Target camshaft position: 155.6 °

CVVT valve duty: 100.0 %

Fuel tank pressure sensor: -0.0 hPa

Actuators test

Controls

Check engine telltale

Fuel pump relay

A/C compressor relay

Main relay

Evaporative emission (EVAP) system, canister purge valve

Oil control valve (CVVT)

Cooling fan high speed relay

Cooling fan low speed relay

Idle Speed Control Valve

Immobilizer telltale

Canister close valve

Canister Close Valve-Clocked

Injectors

Utility

Controls

EVAP leak test

Auto detected configuration reset

Resetting adaptive values

Cylinder Power Balance (Option)

CVVT Test

Idle RPM Control Test(ISC Type Only)

MAF circuit test

TPS Contact Bad Test