Car, KIA, Korea, BONGO3-TRUCK (PU), 2018, D 2.5 TCI-A2(WGT), Transmission (AT)

Transaxle - Transmission (AT) - 0

Identification

Calibration ID:

Software version bootloader:

Software version number:

Supplier ECU software number:

DTC

Controls

Clear DTC

Data stream

Engine speed: 16383.8 rpm

Vehicle speed sensor: 255 km/h

Accelerator pedal position sensor: 100.0 %

Throttle position sensor: 100.0 %

Input shaft speed: 16383.8 rpm

A/T turbine speed 1: 16383.8 rpm

A/T turbine speed 2: 16383.8 rpm

Output shaft speed: 16383.8 rpm

Torque converter slip: 15871.8 rpm

I/C solenoid valve: 100.0 %

I/C solenoid valve: 1020 mA

I/C solenoid valve: 2550 kPa

L/U solenoid valve: 100.0 %

L/U solenoid valve: 1020 mA

L/U solenoid valve: 2550 kPa

H&L R/C solenoid valve: 100.0 %

H&L R/C solenoid valve: 1020 mA

H&L R/C solenoid valve: 2550 kPa

Pressure control solenoid valve: 100.0 %

Pressure control solenoid valve: 1020 mA

Pressure control solenoid valve: 2550 kPa

FR/B solenoid valve: 100.0 %

FR/B solenoid valve: 1020 mA

FR/B solenoid valve: 2550 kPa

D/C solenoid valve duty: 100.0 %

D/C solenoid valve: 1020 mA

D/C solenoid valve: 2550 kPa

On/Off solenoid 1: Not supported

Oil pressure switch 2: Not supported

Fluid temperature-1(Oil Fan): 215 °C

Fluid temperature-2.(Convert Outlet): 215 °C

Gear transmission ratio: 65.535

Gear position (target): -

Gear position (current): -

Shift pattern switch:

Selected lever range:

Inhibitor switch duty: 100.0 %

Hold switch: Not supported

Overdrive off switch: Not supported

Brake pedal switch: Not supported

Torque converter clutch status: Not supported

Inhibitor switch 2: Not supported

Inhibitor switch 3: Not supported

Down shift switch: Not supported

Sport mode: Not supported

Up shift switch: Not supported

Reverse light: Not supported

Shift lock system: Not supported

Ignition 1 signal: Not supported

Starter relay: Not supported

Check engine telltale: On

Number of DTC: 255

Battery voltage: 18.75 V

A/T control relay: 18.75 V

Engine torque: 100.0 %

Driving pattern:

LU calibration gain: -1

LU calibration MAP ID: -1

LU calibration offset: -1

PL calibration MAP ID: -1

PL calibration gain: -1

PL calibration offset: -1

I/C calibration MAP ID: -1

I/C calibration gain: -1

I/C calibration offset: -1

D/C calibration MAP ID: -1

D/C calibration gain: -1

D/C calibration offset: -1

H&L R/C calibration MAP ID: -1

H&L R/C calibration gain: -1

H&L R/C calibration offset: -1

Control valve calibration ID3 high: 65535.0000

Control valve calibration ID2 middle: 65535.0000

Control valve calibration ID1 low: 65535.0000

Unit calibration ID3 (High): 65535.0000

Unit calibration ID2 (Middle): 65535.0000

Unit calibration ID1 (Low): 65535.0000

Actuators test

Controls

D/C solenoid valve

I/C solenoid valve

Torque converter clutch solenoid

HL R/C Solenoid Value

Pressure Control Solenoid Valve(PL)

FR/B solenoid valve

LC/B solenoid valve

Shift Lock System

Starter relay

"P" indicator

"R" indicator

"N" indicator

"D" indicator

Reverse lamp relay

O/D Lamp

Snow Lamp

Utility

Controls

TCU Sub Rom Reset

Resetting Auto T/A Values