Car, ISUZU, RODEO (TF), 4JK1-TC - TransTron
4JK1-TC - TransTron - 0
Identification
VIN no: MPATFS86JJT004883
System identification: TTI 0100
Software version number: 4
System name: 4JK1
Hardware key number: ----------
Programming date: 00 00 00 00
Identifier: 8C 41
Software version number: 98224140
DTC
Controls
Clear DTC
Data stream
Fuel compensation cyl. 1: -- mm³/stk
Fuel compensation cyl. 2: -- mm³/stk
Fuel compensation cyl. 3: 0.00 mm³/stk
Fuel compensation cyl. 4: 0.00 mm³/stk
Accelerator pedal position sensor 1: -- V
Accelerator pedal position sensor 2: -- V
Accelerator pedal position sensor 3: -- V
Accelerator pedal position: 0 %
Barometric pressure sensor: -- V
Battery voltage: -- V
Barometric pressure sensor: -- kPa
Calculated engine load: 0.00 %
Engine coolant temperature sensor: -33 °C
Target fuel rail pressure: -- MPa
Target idle speed: -- rpm
Target throttle position: -- %
Average injection quantity: 0 mm³/stk
Target mass air flow: --
Distance since check engine telltale on: -- km
EGR valve position sensor: -- V
EGR valve position sensor: -- %
EGR solenoid valve: -- %
Engine coolant temperature sensor: -- V
Engine running time: 00:00:00
Time since check engine telltale on: -- min
Engine speed: 0 rpm
Fuel rail pressure: -- MPa
Fuel temperature sensor: -- °C
Fuel rail pressure sensor: -- V
Ignition switch: --
DRM status: --
Neutral switch: --
Starter switch: --
Intake air temperature sensor: -- °C
Intake air temperature sensor: -- V
Throttle position sensor: -- %
Throttle position sensor: -- V
Limp home mode: --
Mass air flow sensor: 0.00 g/sec
Mass air flow sensor: -- V
Check engine telltale: --
Service vehicle soon telltale: --
Glow plug command: --
Swirl flap - control solenoid: --
Glow plug relay command: --
Gear selected: No gear
Vehicle speed sensor: 37 km/h
Engine coolant temperature sensor: -- °C
Target fuel rail pressure: -- MPa
Cam/Crank sensor signal synchronisation status: --
Engine running status: --
Engine overspeed counter: --
Fuel injection time (main): -- °
Main injection activation time: -- ms
Fuel injection quantity (pre): 0 mm³/stk
Actuators test
Controls
Fuel rail pressure control
Pre-injection
Fuel injection timing control valve
Injector cylinder 1
Injector cylinder 2
Injector cylinder 3
Injector cylinder 4
Injector 1 cylinder balance
Injector 2 cylinder balance
Injector 3 cylinder balance
Injector 4 cylinder balance
Intake throttle solenoid control
EGR solenoid valve
Swirl flap solenoid
Glow plug relay
Glow plug lamp
Check engine telltale
Service vehicle soon telltale
Utility
Controls
Supply pump initialization
Injectors replacement