Car, INFINITI, M35 , M45 (Y50), 2006-, Taiwan, PVDOHC - Petrol

PVDOHC - Petrol - 0

Identification

ECU ID: 00 00

Part number: BA011

Program number: 04 01 01 01

DTC

P1122: Electronic throttle control (ETC) system range/performance

P0118: Engine coolant temperature (ECT) sensor - circuit high voltage

P0227: Accelerator pedal position sensor 2/B - circuit low voltage

P0226: Accelerator pedal position sensor 1/A/single range/performance

P0223: Throttle position sensor (TPS) 1/A/single - circuit high voltage

P1224: Throttle position sensor (TPS) 2/B - circuit high voltage

P1126: Electronic throttle control (ETC) motor relay - circuit open

P1610: Lock mode

P1612: Chain of ECM-IMMU

P1111: Intake camshaft position actuator bank 1 - circuit malfunction

P1065: ECM power supply circuit

P0113: Intake air temperature (IAT) sensor 1/A/single - circuit high voltage

P0444: Evaporative emission (EVAP) system canister purge valve - circuit open

Controls

Clear DTC

Data stream

Engine speed: 1800.0 rpm

Distance since check engine telltale on: 0 km

Mass air flow sensor (Bank1): 0.00 V

Injection time bank 1: 0.0 ms

Injection time bank 2: 0.0 ms

Base injection timing: 0.0 ms

Mass air flow sensor: 0.0 g/sec

Accelerator pedal position sensor 1: 0.00 V

Accelerator pedal position sensor 2: 0.00 V

Throttle position sensor 1: 0.00 V

Throttle position sensor 2: 0.00 V

Fuel correction - lower limit: 0.0 ms

Fuel correction - upper limit: 0.0 ms

Mass air flow sensor - lowest value: 0.00 V

Mass air flow sensor - highest value: 0.00 V

A/C pressure sensor: 0.000 V

A/C signal: Off

Throttle closed position: On

Load signal: Off

Start signal: Off

P/N switch: Off

Power steering signal: Off

O2 sensor 2, bank 2: Lean

O2 sensor 2, bank 1: Lean

O2 sensor 1, bank 2: Lean

O2 sensor 1, bank 1: Lean

A/C relay: Off

Option 1: 0

Option 2: 0

CAN diagnostic support monitor

Bus off diagnostic: 0

IPDM E/R: 3

Readiness test

Catalyst monitoring: Complete

A/C system refrigerant monitoring: Complete

O2 sensor monitoring: Complete

Heated catalyst monitoring: Complete

O2 sensor heater monitoring: Complete

Evaporate system monitoring: Complete

EGR system monitoring: Complete

Secondary air injection system monitoring: Complete

Actuators test

Controls

Fuel injection

Ignition timing

Fuel pump relay

V/T ASSIGN ANGLE

Cylinder power balance

Cooling fan

Utility

Controls

Fuel pressure release

Idle air volume learn

Self-learning cont

Adjust ignition angle

Adjust idle speed

Edit VIN