Car, HYUNDAI, General, EQUUS , CENTENNIAL (VI), 2014, G 3.8 GDI, Wiper module (ECW)

Body control module - Wiper module (ECW) - 0

Identification

Part number:

Date :: FF FF FF

Software version number: FF

Hardware version number: FF

Can DB Ver. :: FF FF

DTC

B1602: CAN-bus communication error

B1603: CAN-bus off

B1602: CAN-bus communication error

B1603: CAN-bus off

Controls

Clear DTC

Data stream

Battery voltage: 20.40 V

Wiper cycle counter: 6553500 Cycles

Wiper motor int: On

Ignition status: On

Wiper high speed motor: On

Wiper low speed motor: On

Wiper motor mist: On

Wiper INT. Mode: -

Wiper washer: On

Wiper auto state (Rain Sensor): On

Wiper parking position switch: On

Wiper motor high by auto (Rain Sensor): On

Wiper service position: On

Wiper motor low by auto (Rain Sensor): On

Wiper single (Rain Sensor): On

Snowload OW: On

Ignition 2 signal: On

Snowload IW: On

Wiper low back up: On

Overvoltage: On

Initialisation failure: NG

Undervoltage: On

Stall: On

Wiper temperature sensor error: NG

Wiper motor reference sensor error: NG

Wiper motor speed sensor 1 error: NG

Wiper motor speed sensor 2 error: NG

Wiper voltage sensor error: NG

Wiper temperature state: -

Wiper motor park sensor error: NG

RAM error: NG

H-Bridge Error(Other Shutdown): NG

ROM error: NG

H-Bridge Error(Short/Open Circuit): NG

EEPROM fatal error: NG

Limp home: On