Car, HYUNDAI, General, I20 (PB), 2014, G 1.4 MPI, Smart key code saving (without ESCL) (SMK)
Keyless - Smart key code saving (without ESCL) (SMK) - 0
Identification
Vehicle name:
Part number:
Part name:
Manufacture date:
Software version: FF FF
Product no. ::
Serial number: FF FF FF FF FF
Can DB Ver. :: FF FF
Hardware version number: FF
DTC
B1602: CAN-bus communication error
B1603: CAN-bus off
Controls
Clear DTC
Data stream
Start stop button 2: On
ACC: On
Ignition 1: On
Gearshift P Position(AT)/Clutch(MT): On
Driver door handle toggle button switch: On
Passenger door handle toggle button switch: On
Stop light switch: On
Start stop button 1: On
Trunk lid switch (Tail gate switch): On
Ignition 2: On
Start relay feed back signal: On
Stop lamp fuse status: On
Battery voltage (ADC): 20.40 V
Engine speed: 8160 rpm
Vehicle speed: 255 km/h
ACC relay voltage output: 20.40 V
IGN1 relay voltage output: 20.40 V
IGN2 relay voltage output: 20.40 V
Starter relay voltage output: 20.40 V
Battery voltage monitoring Input(by Load): 20.40 V
Immobilizer telltale: On
External buzzer: On
Start stop button LED blue/green: On
ACC relay output: On
Start stop button illumination GND output: On
Ignition 1 relay output: On
Start stop button illumination power output: On
Ignition 2 relay output: On
Start stop button LED amber: On
Starter relay output: On
IGN1 OFF output: On
IGN2 OFF output: On
Ignition 1 output circuit short to battery: On
ACC output short circuit to Battery(Present): On
Ignition 1 output circuit short to ground: On
ACC output circuit short to ground(Present): On
IGN1 input short circuit to Battery(Present): On
ACC input short circuit to Battery(Present): On
IGN1 input Open(Present): On
ACC input Open(Present): On
Starter output short circuit to Battery(Present): On
Ignition 2 output circuit short to battery: On
Starter output circuit short to ground(Present): On
Ignition 2 output circuit short to ground: On
Starter P/N SW short circuit to Battery(Present): On
IGN2 input short circuit to Battery(Present): On
IGN2 input Open(Present): On
Button status: --
Key n p1 is learnt: --
Key n p2 is learnt: --
Transponder status: --
SMK status: --
Number of learnt FOB key: 255
Actuators test
Controls
Start stop button LED amber
Start stop button LED blue/green
Start Stop Button Illumination
ACC relay
IGN1 Relay
IGN2 Relay
Start Relay
External buzzer
Immobilizer telltale
Interior antenna 1
Interior antenna 2
Trunk antenna (Sedan only)
Bumper/tailgate antenna
Left Door Handle Antenna
Right Door Handle Antenna
Utility
Controls
Interior antenna 1
Interior antenna 2
Trunk antenna (Sedan only)
Bumper/tailgate antenna
Driver door handle antenna
Passenger door handle antenna
ECM neutralization
SMK neutralization
SMK status information
FOB key status information
Current FOB key check
Smart key code saving