PKW, HYUNDAI, General, TUCSON (TLE), 2021, D 2.0 TCI-R, Selective catalytic reduction (SCR)

Vehicle manufacturer ECU software version number:

ECU serial number :: FF FF FF FF FF FF FF FF FF FF FF FF

CVN data :: FF FF FF FF

Vehicle manufacturer ECU hardware number:

Fehlercode löschen

Actuator test identifier for urea dosing valve: -2.410 %

Signal test for urea pressure line heater actuator: EIN

Signal test for urea tank heater actuator: EIN

Urea catalyst upstream temperature: -273.240 °C

DCU temperature: -273.240 °C

Batteriespannung: -0.020 V

State of hydraulic SCR system: -

Last State of Hydraulic SCR-System: -

Substate of Hydraulic SCR-System: Falsch

Last Substate of Hydraulic SCR-System: Falsch

Remaining quantity of reducing agent: -0.0122 %

Remaining quantity of reducing agent: -0.010 L

Remaining quantity of reducing agent: -1 g

Tank level (filtered): -0.0122 %

Status of current tank level: -

State of the defrosting check: No freeze

Motordrehzahl (CAN-Bus): -0.5 UpM

Air pressure CAN: -1 hPa

Lufttemperatur: -273.240 °C

After treatment 1 exhaust gas temperature 1: -273.240 °C

Heater booster enable: Verfügbar

Ladedruck : -1 hPa

Exhaust gas mass flow: -0.1 kg/h

Model value for NOx signal upstream of the SCR catalyst: -0.000

Lambda-Wert: -0.001

Fahrgeschwindigkeit: -0.010 km/h

Engine intake airmass flow rate in EGF1 CAN frame: -0.1 kg/h

Throttle Valve Duty Cycle (received over CAN): -0.0122 %

Stillstandsdauer Motor: -1 sec

Number of warm-up cycles after last clearing of error memory: 255

Temperature field of the SCR catalyst: -273.240 °C

Estimated efficieny of the SCR catalyst: -0.001

Saturation ratio of the SCR catalyst: -0.001

Longterm adaption factor: -0.010

Urea catalyst upstream temperature (Model): -273.240 °C

Relative urea pump module pressure: 65535 hPa

Urea tank temperature: -273.240 °C

Initial refill finished successful: In Ordnung

Tank filling state: -0.250 mm

Output Signal of the Fill Level Height in mm: 16383.750 mm

UREA concentration: 63.750 %

Front NOx concentration: 65535 ppm

Rear NOx concentration: 65535 ppm

Actuator test identifier for urea dosing valve (50%)

Signal test for urea pressure line heater actuator

Signal test for urea tank heater actuator

Actuator test of urea back flow pump actuator (50%)

Signal test for urea solenoid pump (10th)

Initialization of Urea pump pressure value

Initialization of Urea solution system information

Initialization of Urea solution injector temperature

Initialization of Urea solution spraying integration value

Initialization of remaining Urea solution

Initialization of current value Urea solution injector coil

Initialization of current value for Urea solution pump coil

Initialization of Urea solution spraying amount learning value

Initialization of level of ammonia in catalyst

Urea solution collection test

Urea solution collection pump test

Urea solution leak test

Urea solution pressure ready test

Urea solution spraying amount test

Urea solution static spraying test

Urea solution dynamic spraying test

Urea solution small quantity spraying test

Initial filling of urea solution

Urea tank replacement

Urea pump replacement

Austausch des Harnstoffinjektors

DCU replacement

Urea line replacement

Wiring replacement