Car, HYUNDAI, General, SONATA (EF), 2001, G 2.5 DOHC, G 2.5 DOHC - Unleaded OBD-II (ENGINE)

G 2.5 DOHC - Unleaded OBD-II (ENGINE) - 0

Identification

ROM ID:

DTC

Controls

Clear DTC

Data stream

Battery voltage: 25.91 V

Engine coolant temperature sensor: 4.98 V

Engine coolant temperature sensor: 143.2 °C

Intake air temperature sensor: 4.98 V

Intake air temperature sensor: 143.2 °C

Throttle position sensor: 4.98 V

Throttle position sensor: 119.5 °

Adapted throttle position sensor: 119.6 °

Mass air flow sensor: 4.98 V

Mass air flow sensor: 16020.0 kg/h

Vehicle speed: 255 km/h

Engine speed: 65535 rpm

Transmission range switch: Drive

A/C switch: On

A/C compressor relay: On

O2 sensor 1, bank 1: 4.98 V

O2 sensor 1, bank 2: 4.98 V

O2 sensor 2, bank 1: 4.98 V

O2 sensor 2, bank 2: 4.98 V

Ignition angle cylinder 1: -23.6 °

Injection time bank 1: 262.1 ms

Injection time bank 2: 262.1 ms

Fuel system status: On

Short term fuel trim bank 1: 49.6 %

Short term fuel trim bank 2: 49.6 %

Long term fuel trim (idle) bank 1: 131.1 ms

Long term fuel trim (idle) bank 2: 131.1 ms

Long term fuel trim (part load) bank 1: 50.2 %

Long term fuel trim (part load) bank 2: 50.2 %

O2 sensor 1, bank 1, heater coefficient factor: 2.0 0

O2 sensor 1, bank 2 heater coefficient factor: 2.0 0

Idle speed actuator: 100.0 %

Idle speed correction: -0.0 %

Evaporative emission (EVAP) system, canister purge valve: 99.6 %

Cranking signal: On

Closed throttle position switch: On

Fuel tank pressure sensor: -0.000 psi

Long term fuel trim O2 sensor 2, bank 1: 1279.9 ms

Long term fuel trim O2 sensor 2, bank 2: 1279.9 ms

Actuators test

Controls

Check engine telltale

Fuel pump

A/C compressor relay

Cooling fan high speed relay

Cooling fan low speed relay

Main relay

Evaporative emission (EVAP) system, canister purge valve

Idle speed actuator

Ignition coil cylinder 1+4

Ignition coil cylinder 2+5

Ignition coil cylinder 3+6

Injectors

Utility

Controls

Resetting adaptive values

Auto detected configuration reset

EVAP leak test