Car, HYUNDAI, General, SANTAFE (SM), 2003, G 2.7 DOHC, G 2.7 DOHC - Unleaded OBD-II(TiO2) (ENGINE)

ROM ID:

Clear DTC

Battery voltage: 25.91 V

Engine coolant temperature sensor: 4.98 V

Engine coolant temperature sensor: 143.2 °C

Intake air temperature sensor: 4.98 V

Intake air temperature sensor: 143.2 °C

Throttle position sensor: 4.98 V

Throttle position sensor: 119.5 °

Adapted throttle position sensor: 119.6 °

Mass air flow sensor: 4.98 V

Mass air flow sensor: 16023.3 kg/h

Vehicle speed: 255 km/h

Engine speed: 65535 rpm

Target idle speed: 65535 rpm

CKP tooth wheels-CMP rise edge: 255 0

CKP tooth wheels-CMP fall edge: 255 0

Transmission range switch: Drive

A/C switch: On

A/C compressor relay: On

O2 sensor 1, bank 1: 4.97 V

O2 sensor 1, bank 2: 4.97 V

O2 sensor 2, bank 1: 4.98 V

O2 sensor 2, bank 2: 4.98 V

Ignition angle cylinder 1: -23.6 °

Injection time bank 1: 262.1 ms

Injection time bank 2: 262.1 ms

Fuel system status: On

Short term fuel trim bank 1: 49.6 %

Short term fuel trim bank 2: 49.6 %

Long term fuel trim (idle) bank 1: 131.1 ms

Long term fuel trim (idle) bank 2: 131.1 ms

Long term fuel trim (part load) bank 1: 50.2 %

Long term fuel trim (part load) bank 2: 50.2 %

O2 sensor 1, bank 1 heater: 99.6 %

O2 sensor 1, bank 2 heater: 99.6 %

O2 sensor 1, bank 1, heater coefficient factor: 2.0 0

O2 sensor 1, bank 2 heater coefficient factor: 2.0 0

Idle speed actuator: 98.3 %

Evaporative emission (EVAP) system, canister purge valve: 99.6 %

Cranking signal: On

Closed throttle position switch: On

Part load status: On

Fuel tank pressure sensor: -0.000 psi

Check engine telltale

Fuel pump

A/C compressor relay

Cooling fan high speed relay

Cooling fan low speed relay

Main relay

Evaporative emission (EVAP) system, canister purge valve

Idle speed actuator

Ignition coil cylinder 1+4

Ignition coil cylinder 2+5

Ignition coil cylinder 3+6

Injectors

Resetting adaptive values

Auto detected configuration reset

EVAP leak test