Bil, HYUNDAI, General, IONIQ HYBRID (AE HEV), 2018, G 1.6 GDI HEV, ESP, AHB (ESPAHB)

Vehicle name:

Vehicle function ::

ECU version:

Softwareversion:

Clear DTC

Motor Hastighed: -- Omdr.

Køretøjs hastighed : -- km/h

Gasspjælds positions føler: -- %

Shift lever position: --

Batteri spænding: -- V

5v reference voltage: -- V

Venstre forhjulshastighedsføler: -- km/h

Højre forhjulshastighedsføler: -- km/h

Venstre baghjuls hastighedsføler: -- km/h

Højre baghjulshastighedsføler: -- km/h

Steering wheel angle sensor N: --

Steering wheel angle sensor 1: --

Steering wheel angle sensor 2: --

Longitudinal acceleration sensor: -- g

Lateral acceleration sensor: -- g

TCS/ESP warning telltale: --

ABS telltale: --

TCS/ESP off lamp: --

EBD telltale: --

Brake pedal switch normally closed: --

TCS/ESP off switch: --

Hazard switch (ESS only): --

_SYSVAL1: --

DBC/HAC brake lamp relay: --

Motor relay: --

ESS brake lamp relay: --

Valve relay: --

Motor: --

Left rear inlet solenoid valve: --

Left front inlet solenoid valve: --

Right rear inlet solenoid valve: --

Right front inlet solenoid valve: --

Left rear outlet solenoid valve: --

Left front outlet solenoid valve: --

Right rear outlet solenoid valve: --

Right front outlet solenoid valve: --

Left front electric shuttle valve (ESV-LF): --

Left TCS solenoid: --

Right front electric shuttle valve (ESV-RF): --

Right TCS solenoid: --

Reservoir cut valve (PRCV): --

Reservoir cuf-off valve (SRCV): --

Steering wheel angle sensor (CAN): -- °

Lateral acceleration sensor: -- g

Yaw rate sensor: -- °/sec

Pressure sensor (Positive): -- bar

Pressure sensor (Negative): -- bar

Brake pedal travel sensor PDT: -- mm

Brake pedal travel sensor PDF: -- mm

DBC switch: --

DBC telltale: --

Relative steering angle sensor: -- °

Left front brake fluid pressure sensor: 255 bar

Right front brake fluid pressure sensor: 255 bar

Brake vacuum sensor: 6553.5 kPa

Primary pressure sensor - Positive: 255 bar

Primary pressure sensor - Negative: 255 bar

Secondary pressure sensor - Positive: 255 bar

Secondary pressure sensor - Negative: 255 bar

HPA - Positive: 255 bar

HPA - Negative: -- bar

Simulator - Positive: -- bar

Simulator - Negative: -- bar

AHB release valve 1: --

AHB apply valve 1: --

AHB release valve 2: --

AHB apply valve 2: --

AHB simulator valve: --

AHB cuf-off valve 1: --

AHB cuf-off valve 2: --

AHB service lamp: --

AHB warning lamp: --

RBC warning lamp: --

5V power PDT: -- V

5V power PDF: -- V

In-Line coding - SPAS: Completed - smart wheel sensor

In-Line coding - ESS: Completed - enabled

In-Line coding - AVH: Completed - enabled

In-Line coding - HAC: Completed - enabled

In-Line coding - EPB dynamic braking: Completed - enabled

Motor

Forreste venstre indgangsmagnetventil

Forreste højre indgangsmagnetventil

Bageste venstre indgangsmagnetventil

Bageste højre indgangsmagnetventil

Forreste venstre udgangsmagnetventil

Forreste højre udgangsmagnetventil

Bageste venstre udgangsmagnetventil

Bageste højre udgangsmagnetventil

DBC brake lamp relay

ESS brake lamp relay

Release Valve #2

Release Valve #1

Apply Valve #1

Apply Valve #2

Cut Valve #1

Cut Valve #2

Simulator Valve #2

HCU air bleeding

Auto detected configuration reset (ESP(ESC) only)

Longitudinal G Sensor Calibration(HAC/DBC Only)

Pressure sensor calibration

Pedal travel sensor (PTS) calibration

High pressure release mode