Bil, HYUNDAI, General, H-1, IMAX, ILOAD, GRAND STAREX (TQ), 2010, G 2.4 DOHC, G 2.4 DOHC - Leaded All (ENGINE)
G 2.4 DOHC - Leaded All (ENGINE) - 0
Identifikation
Software version bootloader:
ECU software version number: --
Calibration ID:
Fejlkoder
U3FFF: Ukendt fejlkode
Controls
Clear DTC
Levende Data
A/C-kontakt: Tænd
Variant coding: A/T
Gear shift 'D' range: Tænd
A/C status: Tænd
Check motor fejllampe: Tænd
AC compressor: Tænd
Ignition switch: Tænd
Brændstofpumpe: Tænd
Throttle closed position: Tænd
Main relay: Tænd
Throttle full open: Tænd
Camshaft and crankshaft synchronization: Tænd
Fuel cut-off: Tænd
Cranking signal: Tænd
Fuel system status: --
Knocking detection: --
Cranking signal: --
CVVT actuation status: --
Drive status: --
Idle rpm control: --
Belastning Motor: 1535.9 %
Gasspjælds positions føler: 4.98 V
Throttle position PWM servo signal: 100.0 %
Adapted throttle position sensor: 20.4 °
Batteri spænding: 17.37 V
Motor kølevæske temperatur føler: 143.2 °C
Engine coolant temperature sensor (model): -- °C
Intake air temperature sensor: -- °C
Injection time cylinder 1: -- ms
Injection time cylinder 2: -- ms
Injection time cylinder 3: -- ms
Injection time cylinder 4: -- ms
Torque request from TCU: 100.0 %
Target idle speed: 2550 Omdr.
Idle speed actuator: 100.0 %
idle speed actuator offset: 100.0 %
Motor Hastighed: 16383.8 Omdr.
Motorolietemperatur: -- °C
Tændings vinkel: -- °
Køretøjs hastighed : -- km/h
Kortsigtet brændstofafstemning række 1: -0.0 %
Long term fuel trim (idle): -0.0 %
Long term fuel trim (part load): -0.0 %
Knock adaption cylinder 1: 0.0 °
Knock adaption cylinder 2: 0.0 °
Knock adaption cylinder 3: 0.0 °
Knock adaption cylinder 4: 0.0 °
CVVT adaption PWM: 50.0 %
CVVT duty control status: -
Inlet CAM position: 155.6 °
Target camshaft position: 155.6 °
CVVT valve duty: 100.0 %
Udgangs test
Controls
Check motor fejllampe
Brændstofpumperelæ
A/C compressor relay
Main relay
Idle Speed Control Actuator
Oil control valve (CVVT)
Cooling fan high speed
Cooling fan low speed
Immobilizer telltale
indsprøjtnings dyser
Muligheder
Controls
Auto detected configuration reset
Resetting adaptive values
Idle CO adjustment
Rediger stel nr.
Cylinder Power Balance (Option)
CVVT Test
Idle RPM Control Test(ISC Type Only)
ECT Circuit Test