Car, HYUNDAI, General, GENESIS (DH), 2016, G 5.0 GDI, 4WD (4WD)

Vehicle manufacturer ECU hardware number:

Repair shop code or tester serial number:

Programming date: FF FF FF FF

SubSystem boot software number:

SubSystem ECU Software Number ::

Supplier ECU hardware number:

ECU serial number :: --

P3103: Control module - Failure position sensor

Clear DTC

Engine speed: 65535 rpm

Vehicle speed: 255 kph

Target throttle position signal: 99.6 %

Ignition voltage: 25.50 V

Battery voltage: 25.50 V

Computed command torque: 2550 N·m

Computing clutch duty: 255 %

Heat energy: 255 %

Clutch stess: 255 %

4WD warning telltale: Not defined

Actuator voltage: -- V

Actuator shaft angle: -- °

Rotational speed of the actuator: -- rpm

Actuator current: -- A

Calibration angle: -- °

System running time: -- sec

Actual clutch torque: -- N·m

Temperature stress of the actuator: -- %

Failure of position sensor during running cycle: --

Minimum value of motor power supply in case of supply voltage error: -- V

Maximum value of motor power supply in case of supply voltage error: -- V

Mileage: -- km

State of the clutch before actual state of the clutch for output in freeze frames: --

Actual state of the clutch for output in freeze frames: --

Calculated maximum angle change per 2ms in the ignition run: -- rpm

Local conditions in case of an error detection: --

Actual status of vehicle controller: --

Actual state of the clutch controller: --

Diagnostic error flag vehicle controller: --

Counter reading from incremental encoder: -- Tics

Rotational speed proportional signal of the actuator: -- Hz

Vehicle speed: -- km/h

Ignition voltage: -- V

Angle loss between initial position searches: -- °

Combustion engine speed: -- rpm

Output shaft speed: -- rpm

Ratio front axle: --

Ratio rear axle: --

Dynamic wheel radius (Offset of 200 mm): -- mm

Brake active information: --

ESP control mode: --

ESP limitation mode: --

Minimum speed of front axle: -- km/h

Speed of front axle: -- rpm

Speed of rear axle: -- rpm

Delta speed between front and rear axle: -- rpm

Number of conducted calibrations: --

Number of planned calibrations: --

Plate friction energy loss range 1: -- Ws

Plate friction energy loss range 2: -- Ws

Plate friction energy loss range 3: -- Ws

Transmission energy loss in TC due to efficiency factor: -- Ws

Transmission energy loss in clutch due to drag torque: -- Ws

Raw value for calibration angle change: -- °

Information "Which Backup Program is Active": --

Transmission dissipation work due to oil pump losses: -- kWh

Clutch learning reset

T/C Clutch Calibration

Power Down Calibration

HW Characteristics

Torque Coupling Actuation Test

4WD Lamp Actuation Test

Oil Data Initialization