Bil, HYUNDAI, Korea, G70 (IK), 2021, D 2.2 TCI-R, Driveshaft (4WD)
4WD - Driveshaft (4WD) - 0
Identifikation
Software version bootloader:
ECU serial number ::
Vehicle manufacturer ECU hardware number:
Supplier ECU hardware number:
System ECU software number:
Fejlkoder
P183600: Bleed pressure line test error
Controls
Clear DTC
Levende Data
Motor Hastighed: -- Omdr.
Batteri spænding: -- V
Computed command torque: -- N·m
Computing clutch duty: -- %
PCB temperature: -- °C
Computed clutch stress: -- %
AWD warning lamp - ECU failure: --
AWD warning lamp - motor failure: --
AWD warning lamp - clutch failure: --
Køretøjs hastighed : -- km/h
Acceleration pedal: -- %
Brake active information: --
Gear position (current): --
Motor current: -- A
Ratvinkelføler: -- °
Actual clutch torque: -- N·m
Actual clutch pressure: -- bar
Computed motor stress: -- %
Diagnostic flag of ASW (vehicle observer): --
Diagnostic flag of ASW (cluth controller): --
Temporal diagnostic flag of BSW, HW 1: --
Temporal diagnostic flag of BSW, HW 2: --
Diagnostic flag of BSW, HW 1: --
Diagnostic flag of BSW, HW 2: --
Ignition status: --
Output shaft speed: -- Omdr.
Front axle: --
Steering angle offset: -- °
Drejningshastighed: -- °/sec
ESP control mode: --
ESP limitation mode: --
Hetero tire ratio: -- %
Hetero tire level: --
Delta speed between front and rear axle: -- Omdr.
Computed clutch work: -- kWh
Computed motor work: -- kWh
Raw value of sensor output: --
Udgangs test
Controls
Lamp control
Muligheder
Controls
Clutch learning reset
Air Bleeding Mode