Car, HYUNDAI, General, TUCSON , IX35 (LM), 2016, D 2.0 TCI-R, D 2.0 TCI-R - Engine Control (ENGINE)

D 2.0 TCI-R - Engine Control (ENGINE) - 0

Identification

Vehicle manufacturer ECU hardware number:

ROM ID: 2

DTC

Controls

Clear DTC

Data stream

Accelerator pedal position sensor: 100.0 %

Fuel rail pressure control valve: 100.0 %

EGR valve: 100.0 %

Barometric pressure sensor: 3500.0 hPa

Intake air temperature: 200.0 °C

Water temperature: 200.0 °C

Brake pedal switch 1: On

Blower switch: On

A/C pressure low switch: On

Ignition switch: On

Clutch switch (M/T only): On

A/C switch: On

Brake pedal switch 2: On

Accelerator Pedal Position Sensor-1 Voltage: 5000.0 mV

Accelerator Pedal Position Sensor-2 Voltage: 5000.0 mV

Check engine telltale: On

Glow plug relay: 100.0 %

Battery voltage: 25.78 V

Vehicle speed: 300.0 km/h

Mass air flow sensor: 1000.0 kg/h

Cooling fan low speed: On

Cooling fan high speed: On

Fuel pump relay: On

Boost pressure sensor: 2550 hPa

VGT actuator: 100.0 %

Fuel temperature sensor: -- °C

Engine status: --

PTC heater relay: --

Immobilizer telltale: --

Fuel pressure set point: -- hPa

Engine speed: 0.0 rpm

Output of fuel metering unit (MPROP): -- %

A/C pressure sensor: -- mV

A/C pressure sensor: -- psi

Variable swirl actuator: -- %

Diesel Particulate filter (DPF) differential pressure sensor: -- mV

Inlet throttle actuator: -- %

O2 sensor 1, bank 1 subtraction: -- mV

Equivalence ratio (lambda) sensor 1, bank 1: --

O2 sensor 1, bank 1 temperature: -- °C

O2 sensor 1, bank 1 heater: -- %

ECU adaption status: --

Oil level filtered value: -- mm

Oil level filtered value: -- mm

Oil temperature sensor: -- °C

Oil level average value: -- mm

Oil level: --

Exhaust gas temperature before catalyst DPF: 1300.0 °C

Diesel Particulate filter (DPF) charge state: 255

Calculated load value: 100.0 %

Mass air flow per cylinder: 3276.0 mg/strk

Control deviation of the exhaust-gas recirculation control: 1000.0 mg/strk

Undebounced raw value of feedback from glow control unit: On

Check engine telltale: On

Vehicle acceleration: 32.0 m/s²

Actual injection quantity: 100.0 mm³

Maximum rail pressure of the last 10ms: 2000000.0 hPa

Environment temperature: 6280.5 °C

Desired injection quantity (MI1): 100.0 mm³

Target injection quantity (Pilot 1): 100.0 mm³

Target injection quantity (Pilot 2): 100.0 mm³

Target injection quantity (post 1): 100.0 mm³

Target injection quantity (post 2): 100.0 mm³

LP EGR valve feedback position: 100.0 %

LP EGR valve target position: 100.0 %

LP EGR valve control duty: 100.0 %

Differential pressure for LP EGR: 1280.0 hPa

Differential pressure sensor voltage for LP EGR: 10.00 V

Exhaust pressure valve feedback position: 100.0 %

Exhaust pressure valve target position: 100.0 %

Exhaust pressure valve control duty: 100.0 %

Distance since check engine telltale on: 4294967295 km

Main relay error counter: 255

Time since check engine telltale on: 4294967295 min

Variable swirl position: 100.0 %

Variable swirl actuator - duty cycle: 100.0 %

Variable swirl actuator - first learnt value: 100.0 %

Variable swirl actuator - last learnt value: 100.0 %

Diesel Particulate filter (DPF) differential pressure: 32767.0 hPa

AMS stop reason - blower max switch (AMS): Yes

Gear is on neutral position: Yes

Battery current (AMS): -0.1 A

Battery voltage (AMS): 71.535 V

Battery temperature (AMS): 32727.5 °C

State of battery charge (AMS): 255 %

State of health of battery (AMS): 255 %

State of function of battery (AMS): 12.750 V

Desired Alternator Voltage Duty Cycle(AMS): 100.0 %

Duty Cycle from Alternator PWM Signal(AMS): 6402.8 %

Battery sensor in invalid condition (AMS): Yes

Flag status of battery charge (AMS): Yes

Response error flag from battery sensor (AMS): Yes

Flag status of battery health (Aging) (AMS): Yes

Flag status of battery function to crank the engine (AMS): Yes

Flag status of quiescent current (AMS): Yes

AMS stop reason - head lamp (AMS): Yes

AMS stop reason - wiper (AMS): Yes

Actuators test

Controls

A/C compressor relay

Check engine telltale

PTC heater relay

Cooling fan high speed

Cruise Control Main Lamp(Connected by Wire)

Cruise Control SET Lamp(Connected by Wire)

Glow Control Lamp(Connected by Wire)

Glow relay 15%

Immobilizer Lamp(Option)

Boost Pressure Actuator 5%

Boost Pressure Actuator 95%

EGR valve 5%

EGR valve 95%

Throttle valve actuator

Variable swirl control actuator 5%

Variable swirl control actuator 95%

Cooling fan low speed

Engine speed 500 rpm

Engine speed 4000 rpm

EGR cooling by pass 5%

EGR cooling by pass 95%

Generator control

Fuel pump

Low Pressure EGR Valve 5%

Low Pressure EGR Valve 95%

Low Pressure Exhaust Flap 5%

Low Pressure Exhaust Flap 95%

Utility

Controls

Compression test

Idle speed comparison

Injection quantity comparison

ECU Change (CPF option)

Lambda sensor change

Rail pressure sensor change

Air Flow Sensor Change

CPF Change (CPF option)

Differential pressure sensor replacement (CPF option)

Swirl control valve change

Throttle adaptation reset

EGR valve change

Low EGR valve change

Injectors replacement

Fuel line air removal

CPF Service Regeneration (CPF option)

ECU Tuning Data Confirm