Car, HYUNDAI, America, GENESIS (DH), 2017, G 5.0 GDI, 4WD (4WD)
4WD - 4WD (4WD) - 0
Identification
Vehicle manufacturer ECU hardware number:
Repair shop code or tester serial number:
: 1193046:28:15
SubSystem boot software number:
SubSystem ECU software number:
Supplier ECU hardware number:
SubSystem boot software number:
SubSystem ECU software number:
Vehicle manufacturer ECU hardware number:
Supplier ECU hardware number:
Repair shop code or tester serial number:
: 1193046:28:15
ECU serial number :: --
DTC
P1736: Motor - circuit open or short to battery
Controls
Clear DTC
Data stream
Engine speed: 0 rpm
Vehicle speed: 0 kph
Target throttle position signal: 99.6 %
Ignition voltage: 25.50 V
Battery voltage: 25.50 V
Computed command torque: 2550 N·m
Computing clutch duty: 255 %
Heat energy: 255 %
Clutch stess: 255 %
4WD warning telltale: Off
Actuator voltage: -0.03 V
Actuator shaft angle: -0.0 °
Rotational speed of the actuator: -0.0 rpm
Actuator current: -0.1 A
Calibration angle: -0.0 °
System running time: 65535 sec
Actual clutch torque: -0.1 N·m
Temperature stress of the actuator: 255 %
Failure of position sensor during running cycle: 255
Minimum value of motor power supply in case of supply voltage error: 25.50 V
Maximum value of motor power supply in case of supply voltage error: 25.50 V
Mileage: 4294967295 km
State of the clutch before actual state of the clutch for output in freeze frames: 255
Actual state of the clutch for output in freeze frames: 255
Calculated maximum angle change per 2ms in the ignition run: 255 rpm
Local conditions in case of an error detection: 65535
Actual status of vehicle controller: 255
Actual state of the clutch controller: 255
Diagnostic error flag vehicle controller:
Counter reading from incremental encoder: -1 Tics
Rotational speed proportional signal of the actuator: -1 Hz
Vehicle speed: -0.0 km/h
Ignition voltage: 255.00 V
Angle loss between initial position searches: -0.0 °
Combustion engine speed: 65535 rpm
Output shaft speed: -0.2 rpm
Ratio front axle: 8.0
Ratio rear axle: 8.0
Dynamic wheel radius (Offset of 200 mm): 455 mm
Brake active information: 255
ESP control mode: 255
ESP limitation mode: 255
Minimum speed of front axle: -0.0 km/h
Speed of front axle: -0.2 rpm
Speed of rear axle: -0.2 rpm
Actuators test
Controls
Torque coupling control
4WD Lamp Control
Utility
Controls
Clutch learning reset
T/C Clutch Calibration
Power Down Calibration
HW Characteristics