Car, HOLDEN, Captiva 5, 2014, ABS
Brake system - ABS - 0
Identification
Code version: --
VIN no: W0LGT8EBXA1007787
System identification: BOSCH0100
System name: --
ECU diagnostic address: 01
Software module 1 identifier: 12654173
Calibration part number: 55577673
End model part number: 55577619
Base model part number: 55574337
DTC
C0035: Left front wheel speed sensor - circuit malfunction
C0040: Right front wheel speed sensor circuit
C0045: Left rear wheel speed sensor - circuit malfunction
Controls
Clear DTC
Data stream
System voltage: 0.0 V
Steering column position: 0 °
ABS control status: Ok
Vehicle stability system status: Ok
Traction control system status: Ok
Panic brake assist status: Ok
Engine drag control status: Ok
Dynamic rear proportioning status : Ok
Tire pressure monitoring indicator: Inactive
Vehicle stability system: Inactive
ABS: Inactive
Brake traction control system: Inactive
Dynamic rear proportioning: Inactive
Left front wheel speed sensor: 0 km/h
Right front wheel speed sensor: 0 km/h
Right rear wheel speed sensor: 0 km/h
Left rear wheel speed sensor: 0 km/h
Lateral acceleration: 0.00 m/s²
Longitudinal acceleration: 0.00 m/s²
Yaw rate signal: 0.00 °/sec
Brake pressure sensor: 0 bar
ABS pump motor: 0.0 V
Vehicle Stability System Switch: Inactive
Traction control switch: Inactive
Brake fluid level sensor: Ok
Brake pedal position sensor: Inactive
ABS telltale: Inactive
Traction control telltale: Inactive
Steering wheel angle sensor centering: Not Ok
System voltage: 0.0 V
Left front inlet solenoid valve command: Off
Left rear inlet solenoid valve command: Off
Left front outlet solenoid valve command: Off
Left rear outlet solenoid valve command: Off
Right front inlet solenoid valve command: Off
Right rear inlet solenoid valve command: Off
Right front outlet solenoid valve command: Off
Right rear outlet solenoid valve command: Off
Secondary isolation solenoid valve feedback: Inactive
Primary isolation solenoid valve feedback: Inactive
Secondary isolation solenoid valve command: Inactive
Primary isolation solenoid valve command: Inactive
ABS pump motor: 0.0 V
Actuators test
Controls
ABS pump motor
Utility
Controls
Steering wheel sensor learning