Car, FIAT, FREEMONT (345), 2.0 16V - Diesel
2.0 16V - Diesel - 0
Identification
VIN no: bK~ K~ ñ bK~
VIN no (original): bK~ K~ ñbK~
Serial number: bK~ K~ ñbK~
Drawing number: bK~ K~ ñ2
Homologation code: bK~ K~ ñ
Country code:
Vehicle line:
Model year: 100
Body style:
Diagnostic version: 4B
Diagnostic variant: 7E
DTC
Controls
Clear DTC
Data stream
Accelerator pedal position: -- %
Generator current: -- mA
Air flow rate from mass air flow sensor: -- mm³/inject
Target turbocharger boost pressure: -- mbar
Air Temperature At HFM Position: 2952.46 °C
Intake manifold air temperature: -- °C
Calculated air flow: 0.00 kg/h
Fan stage 2: Activated
Fan stage 1: Activated
A/C compressor on: False
Ambient temperature: -- °C
Coolant temperature: -- °C
Target mass air flow: -- mm³/inject
Target mass air flow: -- mm³/inject
Mass air flow per cylinder: -- mg/strk
Generator load: -- %
Generator setpoint voltage: -- mV
Generator regulator setpoint: -- mV
Ambient air pressure: -- mbar
Battery voltage after defect detection and handling: -- mV
EGR control status: Disabled
Boost pressure "A" control status: Disabled
EGR cooler bypass valve: On
Water in fuel: Not present
Request to switch on/off the main relay: On
Main brake information: Not pressed
Ignition status: Key off
Starter relay control: Off
Cruise control key status: --
Clutch pedal: Pressed
Engine cranking status: False
Electric fuel pump active: False
Starter relay status: Not engaged
Cruise control switch (1):
Defrost button: True
Engine cranking status: True
Pre supply pump command on: False
EGR control status: Disabled
Boost pressure "A" control status: Disabled
EGR cooler bypass status: On
Water in fuel: Not present
Lambda / Particulate filter presence:
Normal regeneration active: True
Regeneration active (forced regeneration from diagnostic tool): False
MT set by calibration: True
Engine oil pressure switch: On
EGR: Off
Presupply pump activation status:
Starter relay:
Commanded wastegate A position: -- %
Cruise control reference speed: 5.1 km/h
Current regulator valve DRV: -- mA
Current regulator valve M-Prop (Metering unit): -- mA
Differential pressure sensor: -- hPa
Duty cycle: -- %
Duty cycle regulator valve DRV: -- %
Duty cycle regulator valve M-Prop (Metering unit): -- %
EGR valve position: -- %
EGR solenoid valve: -- %
Engine coolant temperature: -- °C
Engine speed: -- rpm
Evaporator temperature: -- °C
Fuel rail pressure sensor: -- bar
Target fuel rail pressure: -- bar
Diesel Particulate filter (DPF) inlet temperature: -- °C
Intake air temperature: -- °C
Intake manifold air temperature: -- °C
O2 sensor 1, bank 1: -- mV
O2 sensor 1, bank 1 temperature: -- °C
O2 sensor 1, bank 1 heater duty cycle: -- %
Maximum rail pressure of the last 10ms: -- bar
Odometer: -- km
Diesel Particulate filter (DPF) soot mass: -- %
Pressure: -- %
Injected fuel quantity: -- mm³/inject
Fuel rail pressure: 1610000.0 hPa
Target fuel rail pressure: 1260000.0 hPa
Raw value of rail pressure: -- mV
Raw voltage of temperature at upstream of the DPF: -- mV
Battery voltage: -- mV
Engine coolant temperature sensor: -- °C
Fuel temperature: -- °C
Inlet air temperature sensor: -- °C
Ambient air pressure: -- hPa
Oil pressure: -- hPa
Temperature sensor upstream of particulate filter: -237.14 °C
Sensed value of the temperature at TTrbnUs: -- °C
Pressure before turbine: 32256 hPa
Throttle valve actuator: -- %
Fuel consumption correction cylinder 1: -- mg/strk
Fuel consumption correction cylinder 4: -- mg/strk
Fuel consumption correction cylinder 3: -- mg/strk
Fuel consumption correction cylinder 2: -- mg/strk
Turbine upstream temperature sensor: -- mV
Vehicle speed: -- km
VGT position: -- km
Actuators test
Controls
Air conditioner
Crankcase ventilation valve
Glow plug relay
Boost pressure actuator
Fuel filter heater
Water in fuel telltale
PTC heater 1
PTC heater 2
PTC heater 3
Check engine telltale
Starter
Pre-supply pump
EGR valve motor
Variable swirl actuator
Metering unit
Variable fan duty cycle
Glow telltale
Utility
Controls
Reset oil change
EGR valve replacement
Air flow meter sensor replacement
Glow plug preheating circuit test
O2 sensor replacement
Fuel rail pressure sensor replacement
Replacement of control unit and injectors
Idle increase for TCM quick learn
Configuration
Controls
Edit configuration