Car, CITROEN, C3 Picasso, BSM
Power source control - BSM - 0
Identification
ECU manufacturer: Valeo
Equipment number: 96 60 37 64 80
VIN no: VF7UA5FV8AJ797826
Model: C4 Picasso
Additional number: 96 64 99 77 80
DTC
F56A: Supply protection and management unit fault: central power switch positive supply relay detected open while driving while the main relay is active
Controls
Clear DTC
Data stream
Water pump control for exhaust gas heat recovery for heating the passenger compartment: Inactive
Additional heating with resistors: CTP1 and CTP2 additional resistance
A/C blower unit command by the CAN: 15 %
A/C compressor: Active
Compressor authorisation output control: Active
Reverse gear: Yes
Vehicle and trailer left indicator illumination control: Active
Horn control: Yes
Dipped beam illumination control: Active
Front fog lamps: Active
Main beam: Active
Vehicle and trailer right indicator illumination control: Active
Vehicle and trailer right side lamps illumination control: Yes
Vehicle and trailer left side lamps illumination control: Yes
Measured oil level: 106 %
Oil temperature: -38 °C
Oil pressure warning lamp: No
Windscreen wiper control: fast speed
Control of headlamp wash or of engine running output: Active
Rear screen wash control: Inactive
Windscreen wash control: Active
Windscreen wiper parked position: Active
Ignition switch position: Key not in +CRANK position
Auto / Sensodrive gearbox lever position seen by engine relay unit (BSM): Unknown
Actuators test
Controls
Horn control
Windscreen wiper (low speed)
Windscreen wiper (high speed)
Rear screen wash control
Windscreen wash control
Control of headlamp wash or of engine running output
A/C compressor control
Exit economy mode
Check on dipped lights
Check main beam lights