Car, CITROEN, C4 Picasso, BSI

Body control module - BSI - 0

Identification

PSA reference: 96 64 05 87 80

ECU manufacturer: Valeo

Additional number: 96 74 02 11 80

Diagnostic version: 0B

Calibration version: FF FF

Software version: 0B 32

Software reference: 77 72 45

VIN no: VF7SH5FP0AT538803

Software reference: 77 72 45

DTC

F5FF: Unexpected re-initialisation fault coming from the BSI

Controls

Clear DTC

Main Supplies

Battery voltage: 14.20 V

Generator excitation voltage: 1.70 V

BSI software resets: 5

BSI hardware resets: 10

Engine start: Yes

Protected battery voltage: 13.40 V

Fuel pump power supply cut-off: Inactive

Key in starter position: No

Emergency mode: Inactive

BSI memory following downloading: Empty

Air conditioner

A/C evaporator temperature sensor: 1.0 °C

Refrigerant pressure: 10.6 bar

Additional resistors PTC1 and PTC2 control: no control

A/C blower unit command by the CAN: 0 %

Fan assembly control via the CAN: 0 %

A/C operating mode: Stopped

Displayed blower reference value: 2 speed

Request for A/C compressor power reduction: No request

Engine coolant safety device: Active

A/C refrigerant compressor: Inactive

Evaporator icing up safety status: Inactive

Compressor authorisation output control: Inactive

Compressor authorisation information: Inactive

Request to A/C compressor: Inactive

User request to start the A/C: Active

A/C pressure sensor: Faulty

High pressure safety: Inactive

Outside air temperature: Faulty

Low pressure safety: Inactive

Evaporator temperature sensor: Faulty

Engine speed safety device: Inactive

A/C compressor clutch: Released

Driving

Cruise control/speed limiter: status of the selection: Regulation

Automatic gearbox lever position: Automatic

Cruise control or speed limiter: status of the speed: Waiting or not effective

Interior brightness level: 54

Cruise control/speed limiter: speed request +: Yes

Cruise control/speed limiter: speed request -: No

Cruise control/speed limiter: No

Handbrake: No

Request for A/T snow mode: No

Brake pedal position: No

Request for A/T sport mode: No

Cruise control/speed limiter: activation status: Inactive

Left rear seatbelt buckle switch: Yes

Reverse gear: Yes

Right rear seatbelt buckle switch: Yes

Left front seatbelt buckle switch: Yes

Centre rear seatbelt buckle switch: Yes

Right front seatbelt buckle switch: Yes

Cruise control/speed limiter: status of the "Cancel/Resume" button: Inactive

Diagnostics P/N switch (automatic gearbox) or status of starting authorisation (Controlled gearbox): P/N switch functional or starting authorised

Back panel mode: Active

Lighting - Signalling

Front courtesy light control: 176 %

Rear courtesy light control: 11 %

Control of lighting of the interior controls and displays: 13 %

Boot and/or rear courtesy lamp lighting control: 0 %

Request for switching on of courtesy light: Yes

Side lights switch: Yes

Automatic light sensor: Inactive

Alarm

Interior intrusion detection: Yes

Interior protection deactivation request: Yes

Data stream

Transponder key: 2

Remote control key 5 synchronized: No

Remote control key 1 synchronized: No

Engine control unit locked: Yes

Remote control key 2 synchronized: No

Transponder label recognised: Yes

Remote control key 3 synchronized: No

Remote control key 4 synchronized: No

Engine coolant temperature: 214 °C

Oil temperature: -40 °C

Outside air temperature: 38.0 °C

Battery charge: Inactive

Actuators test

Controls

A/C compressor control

PTC additional heating resistor 1 control

PTC additional heating resistor 2 control

Additional resistors PTC1 and PTC2 control

Courtesy light control

Check on dipped lights

Check main beam lights

Check on output with engine running

Horn control

Locks locking control

Locks unlocking control

Battery charge telltale

Seat belt warning telltale

CDS deactivation warning telltale (ESP)

Windscreen wash control

Windscreen wiper (low speed)

Windscreen wiper (high speed)

Rear screen wash control

Rear wiper

Control of headlamp wash or of engine running output

Demisting control

Utility

Controls

Maintenance indicator reset

Activation of stop/start (New vehicle)

Zero reset of the counter for the number of restart (start/stop and hybrid)