Car, GWM, SOCOOL, Spaceflight MIT ECU system (ECM)

Engine - Spaceflight MIT ECU system (ECM) - 0

Identification

Part number: DEL 0109355289

ECU data: 522

DTC

1664: Unknown DTC

Controls

Clear DTC

Data stream

Number of DTC: 22

MAP sensor: 45.8 kPa

MAP sensor: 1.875 V

Battery voltage: 8.20 V

Intake air temperature sensor: -18.2 °C

Engine coolant temperature sensor: 18.5 °C

Ignition angle: 23.2 °

A/C pressure sensor: 620.0 kPa

Throttle position sensor: 3.027 V

Throttle position sensor: 23.2 %

Vehicle speed sensor: 26 km/h

Engine speed: 1000 rpm

Injection time bank 1: 29.7 ms

IAC control: 33 steps

Calculated air flow: 27.0 %

Target idle speed: 912.5 rpm

O2 sensor 1, bank 1: 0.393 V

O2 integrator: 32 steps

O2 BLM cell number: 30

O2 BLM cell content: 65

O2 cross over: 97 Counts

Evaporative emission (EVAP) system, canister purge valve: 59.4 %

Air/Fuel ratio: 5.0 :1

Power enrichment: Enable

O2 sensor loop control bank 1: Disable

O2 sensor loop control bank 1: Rich

Clear flood mode: Enable

Torque control signal: Active

Normal IAC closed loop mode: Enable

P/N switch: D

IAC control: Active

Fuel pump relay: Enable

A/C request: Active

A/C pressure sensor: High

A/C relay: Active

Air conditioner: Present

Ignition status: On

Check engine telltale: On

Vehicle transmission type: A/T

O2 sensor 1, bank 1 heater: On

Barometric pressure sensor: 38.0 kPa

Time since engine start: 4692 sec

Volumetric efficiency: 79.7 %

Charge air temperature sensor: 47.0 °C

Mass air flow sensor: 36 gm/s

Fuel consumption: 19398.7 ms

Actuators test

Controls

Check engine telltale

Evaporative emission (EVAP) system, canister purge valve

Fuel pump relay

Ignition coil

A/C relay

Cooling fan relay 1

Ignition angle

Idle rpm control

Air/Fuel ratio

EGR Control

Idle speed actuator

Evaporative emission (EVAP) system, canister purge valve

Injectors