Car, BMW, 3 (E90), Transmission control module (EGS)

Transaxle - Transmission control module (EGS) - 0

Identification

Part number: 07 55 60 39

Hardware number: 13

Variant index: MH

Diagnostic version: 02 02

Production date: 05.12.2015

Code index: 02

Supplier: Bosch

Message catalogue version: 0.16.96

Functional software version: 0.16.96

Operating safety software version: 2.3.10

Chassis: DL93734

Hardware number: 07 52 35 23

DTC

4E20: Electronic pressure control valve 1

Controls

Clear DTC

Data stream

Accelerator pedal angle: 8.15 %

Actual engine torque: 28.0 N/m

Battery voltage: 5.44 V

Engine speed: 5696.0 rpm

Level M gate: Low

Level on L1 pin: Low

Level on L2 pin: Low

Level on L3 pin: Low

Level on L4 pin: High

Level on tip+: Low

Level on tip-: Low

Transfer case oil temperature: 54.0 °C

Engine oil temperature: -9.0 °C

Output speed: 4160.0 rpm

Torque converter turbine speed: 1440.0 rpm

Pressure actuator/solenoid valves: 8.16 V

Wheel speed: 460.0 km/h

Brake signal: O.K.

Detection, diretion of wheel rotation: O.K.

Left front wheel speed sensor: O.K.

Right front wheel speed sensor: O.K.

Right rear wheel speed sensor: Substitute value / fault

Left rear wheel speed sensor: O.K.

Accelerator pedal switch: O.K.

Engine speed: Substitute value / fault

Torque interface: Substitute value / fault

Accelerator pedal switch: O.K.

Temperature sensor, mechatronics: O.K.

Temperature sensor, transmission: Substitute value / fault

Torque converter turbine speed: Substitute value / fault

Actual gear: -

Brake depressed: Enable

Door CAN signal (CAS): Closed

Terminal CAN signal 15 (CAS): Off

Wake up line (CAS): High

Torque converter lock-up clutch status: Open

Program switch: ACC

Transmission position: -

Clutch adaptations deactivated: Not active

3rd or 5th gear electric limp home operation: Active

Torque converter clutch lock up open: Not active

Hold gear: Not active

5th gear and holding gear limp home program: Not active

4th gear and holding gear limp home program: Not active

No S/M program: Not active

P/N lock deactivated: Not active

Substitute value wheel speed output speed: Active

Substitute value output speed wheel speed: Not active

Transmission deactivation relay: Not active

Maximum main pressure: Not active

Mechanical limp - home mode: Not active

Idle neutral control: Not active

Solenoid valve 3 interlock deactivated: Not active

Solenoid valve 4 interlock deactivated: Not active

Starting - torque limitation: Not active

1st gear electric limp home operation: Not active

2nd gear electric limp home operation: Not active

4th gear electric limp home operation: Not active

3rd gear electric limp home operation: Not active

3rd gear and holding gear limp home program: Not active

No position, R gear: Not active

Interlock: -

Shift lock: Off

Solenoid valve 1: Off

Solenoid valve 3: -

Solenoid valve 4: Off

Filling pressure, clutch A: -33.00 mbar

Filling pressure, clutch B: 22003.66 mbar

Filling pressure, clutch C: 20302.69 mbar

Filling pressure, clutch D: 13300.80 mbar

Filling pressure, clutch E: -154.00 mbar

Rapid filling time, clutch A: -32748.50 ms

Rapid filling time, clutch B: 8948.86 ms

Rapid filling time, clutch C: 24564.63 ms

Rapid filling time, clutch D: -8891.86 ms

Rapid filling time, clutch E: -555.99 ms

Actuators test

Controls

Solenoid valve, shift lock

Solenoid valve, inter lock

Resetting of all adaptation values

Teach in components

Configuration

Controls

Edit configuration

Configuration

Controls

Edit configuration

Configuration

Controls

Edit configuration