Car, BRILLIANCE, JINBEI, Delphi 491ME (ECM)
Engine - Delphi 491ME (ECM) - 0
DTC
P0501: Vehicle speed sensor 1/A/single range/performance
P1523: Unknown DTC
Controls
Clear DTC
Data stream
Number of DTC: 0
Barometric pressure sensor: 10.0 kPa
Calculated catalytic converter temperature: 300.0 °C
Intake air temperature sensor: 0.00 V
Engine coolant temperature sensor: 0.00 V
Target idle speed actuator: 0 steps
Throttle position sensor: 0.00 V
Time since engine start: 32513 sec
Ignition angle: -90.0 °
Engine speed: 0.0 rpm
Injection time bank 1: 0.0 ms
Idle speed actuator: 0 steps
Throttle position sensor: 0.0 %
Evaporative emission (EVAP) system, canister purge valve: 0.0 %
MAP sensor: 10.0 kPa
O2 sensor 1, bank 1: 0.000 V
Battery voltage: 0.00 V
Engine coolant temperature sensor: 0.0 °C
Intake air temperature sensor: 0.0 °C
Target engine speed: 0.0 rpm
Air/Fuel ratio: 0.0 :1
Vehicle speed sensor: 0 km/h
Power enrichment: No
O2 sensor loop control bank 1: Open Loop
Deceleration fuel cut-off: Off
Air/Fuel ratio: Lean
Acceleration fuel enrichment: Off
Block learn: Not active
Clear flood mode: Not active
A/C run: No
A/C temperature sensor: Not active
Diagnostic request: Off
A/C request: Off
Fuel pump: Off
A/C cut-off due to throttle wide open: Not active
A/C clutch: Off
Torque converter slip: Disable
Knocking protection: Disable
A/C cut-off due to full load (no delay): Not active
Immobilizer
Immobilizer status: Active
Wrong transponder key: Yes
Actuators test
Controls
Check engine telltale
Evaporative emission (EVAP) system, canister purge valve
Fuel pump relay
A/C relay
Idle rpm control
Air/Fuel ratio
Idle speed actuator
Ignition angle