Car, GEELY, Free Cruiser (CK, CK-1, OTAKA), Delphi MT20U (ECM)
Engine - Delphi MT20U (ECM) - 0
Identification
VIN no: 123456789ABCDEFGH
Serial number: IQRSTUVWXY
Programming date: 42 25 44 35
Part number: DEL450309013770
2WD/4WD type: 2WD
Serial number: 13876
Type: EURO53
Engine type: 4G64
DTC
Controls
Clear DTC
Data stream
Number of DTC: 6
MAP sensor: 100.0 kPa
MAP sensor: 4.746 V
Battery voltage: 12.30 V
Intake air temperature sensor: 58.2 °C
Engine coolant temperature sensor: 74.6 °C
Ignition angle: 2.1 °
A/C pressure: 0 kPa
Knock sensor: 1.191 V
Knock retard angle cylinder 1: 0.0 °
Knock retard angle cylinder 2: 0.0 °
Knock retard angle cylinder 3: 0.0 °
Knock retard angle cylinder 4: 0.0 °
Throttle position sensor: 0.469 V
Throttle position sensor: 0.0 %
Vehicle speed sensor: 0 km/h
Engine speed: 57 rpm
Injection time bank 1: 20.7 ms
Idle speed actuator: 77 steps
Target idle speed: 987.5 rpm
O2 sensor 1, bank 1: 0.469 V
O2 BLM cell number: 19
O2 BLM cell content: 154
Evaporative emission (EVAP) system, canister purge valve: 0.0 %
Air/Fuel ratio: 10.3 :1
EGR valve command: 0.0 %
Linear EGR feedback: 0.0 %
Power enrichment: Not active
O2 sensor 1, bank 1: Rich
Block learn: Not active
Clear flood mode: Not active
Torque control signal: Not active
Normal IAC closed loop mode: Not active
Idle speed actuator: Not active
Fuel pump relay: Off
A/C request: Off
A/C pressure sensor: Off
A/C relay: Off
Ignition switch: On
Cooling fan low speed: Off
Check engine telltale: On
Cooling fan high speed: Off
Vehicle transmission type: MT
O2 sensor 1, bank 1 heater: Off
Odometer: 100000.0 km
Barometric pressure sensor: 100.3 kPa
Engine running time: 0 sec
Engine volume efficiency: 79.7 %
O2 sensor 2, bank 1: 0.451 V
Mass air flow sensor: 2 g/sec
Actuators test
Controls
Check engine telltale
Evaporative emission (EVAP) system, canister purge valve
Fuel pump relay
Cooling fan low speed
Cooling fan high speed
A/C relay
Ignition angle
Air/Fuel ratio
EGR Control
Idle speed actuator
Evaporative emission (EVAP) system, canister purge valve
Ignition coil
Injectors
Adjust idle speed P-N
Adjust idle speed drive
Dwell time
Volumetric efficiency
Utility
Controls
Reset Idle speed actuator learn map
Reset O2 loop block learn map
Reset knock learn map
ECU Reset