Car, ZX, LANDMARK, 4G64 - Delphi MT20U (ECM)

Part number: DEL 0309013770

Serial number: 2

P0325: Knock sensor 1, bank 1 - circuit malfunction

P0170: Fuel trim system, bank 1 malfunction

P0135: O2 sensor 1, bank 1 heater - circuit malfunction

P0105: Manifold absolute pressure (MAP)/Barometric pressure - circuit malfunction

P0110: Intake air temperature (IAT) sensor 1/A/single - circuit malfunction

P0130: O2 sensor 1, bank 1 - circuit malfunction

Clear DTC

Number of DTC: 6

MAP sensor: 29.2 kPa

MAP sensor: 0.996 V

Battery voltage: 14.30 V

Intake air temperature sensor: 71.0 °C

Engine coolant temperature sensor: 91.8 °C

Ignition angle: 7.0 °

A/C pressure: 0 kPa

Knock sensor: 0.195 V

Knock retard angle cylinder 1: 0.7 °

Knock retard angle cylinder 2: 1.8 °

Knock retard angle cylinder 3: 0.0 °

Knock retard angle cylinder 4: 1.8 °

Throttle position sensor: 0.352 V

Throttle position sensor: 0.0 %

Vehicle speed sensor: 0 km/h

Engine speed: 801 rpm

Injection time bank 1: 3.2 ms

Idle speed actuator: 29 steps

Target idle speed: 800.0 rpm

O2 sensor 1, bank 1: 0.438 V

O2 BLM cell number: 18

O2 BLM cell content: 154

Evaporative emission (EVAP) system, canister purge valve: 0.0 %

Air/Fuel ratio: 14.6 :1

EGR valve command: 0.0 %

Linear EGR feedback: 0.0 %

Power enrichment: Not active

O2 sensor 1, bank 1: Lean

Block learn: Active

Clear flood mode: Not active

Torque control signal: Not active

Normal IAC closed loop mode: Active

Idle speed actuator: Not active

Fuel pump relay: On

A/C request: Off

A/C pressure sensor: Off

A/C relay: Off

Ignition switch: On

Cooling fan low speed: Off

Check engine telltale: Off

Cooling fan high speed: Off

Vehicle transmission type: MT

O2 sensor 1, bank 1 heater: On

EGR valve position: 0.0 mV

Odometer: 104206.6 km

Barometric pressure sensor: 98.1 kPa

Engine running time: 247 sec

Engine volume efficiency: 66.4 %

O2 sensor 2, bank 1: 0.299 V

MAP altitude compensate: 30.3 kPa

Mass air flow sensor: 8 g/sec

Check engine telltale

Evaporative emission (EVAP) system, canister purge valve

Fuel pump relay

Cooling fan low speed

Cooling fan high speed

A/C relay

Ignition angle

Air/Fuel ratio

EGR Control

Idle speed actuator

Evaporative emission (EVAP) system, canister purge valve

Ignition coil

Adjust idle speed P-N

Adjust idle speed drive

Volumetric efficiency

Dwell time

Injectors

Reset Idle speed actuator learn map

Reset O2 loop block learn map

Reset knock learn map

ECU Reset