Car, LADA, GRANTA, 11182 (1.6 L SOHC) - M74.9 CAN (PCM)
11182 (1.6 L SOHC) - M74.9 CAN (PCM) - 0
Identification
VIN no: XTA219010D0209571
Part number: 11186-1411020-22
ECU ID: M74.9 0327
Version: NOTSUPPORT
Software ID: NOTSUPPORT
Software version: --
Emission: --
Engine type: GRANTA-1.6L, 8V
Repair shop code or tester serial number: 0207772
Software date: 02-10-2012
Identifier: I812NA01
Immobilizer password: 0000
Immobilizer failed: No
ECU learnt: No
Fast start: Yes
ECU blocked: No
Immobilizer bypass: Not allowed
Immobilizer password learned: No
Body number:
Engine number: 6056227
Manufacture date: 02-09-2013
ROM checksum : --
DTC
P0201: Injector cylinder 1 - circuit malfunction
P0363: Misfire with fuel injection cut-off
P1304: Misfire detected for catalyst damage, cylinder 4
P1301: Misfire detected for catalyst damage, cylinder 1
Controls
Clear DTC
Data stream
Number of DTC: 0
Battery voltage: 12.50 V
Engine coolant temperature sensor: 90.8 °C
Engine speed: 0 rpm
Vehicle speed sensor: 0.0 km/h
Ignition advance angle: -11.2 °
Injection time bank 1: 0.00 ms
Throttle position sensor: 7.5 %
Accelerator pedal position sensor: 0.0 %
Относительное заполнение воздухом: 100.0 %
Target equivalence ratio (lambda) sensor 1, bank 1: 0.900
O2 sensor 1, bank 1: 0.885 V
O2 sensor 1, bank 1 period: 0.525 ms
O2 sensor 2, bank 1: 1.155 V
Current correction O2 sensor 1, bank 1: 1.000
Barometric correction: 1.0
Адаптируемые утечки дросселя: -0.3 kg/h
Multiplicative term fuel trim bank 1: 0.980
O2 sensor 2, bank 1 regulation (I part): -0.02637
Catalyst deteriorate: 0.0
Fuel consumption: 0.0 L/h
Intake air temperature sensor: 74.2 °C
Canister purge coefficient: 0.0 %
Концентрация топлива в адсорбере: 0.5
Knock retard angle: -81.0 °
Target idle speed: 940 rpm
Разница крутящего момента от адаптированного крутящего момента: -0.9 %
Throttle leak: 1.5
Idle speed requirement (I): 0.0 %
Idle speed requirement (PD): 4.6 %
Coolant temperature at engine start: 90.6 °C
Catalyst check: Not complete
Canister purge check: Complete
O2 sensor 1, bank 1 check: Not complete
O2 sensor 2, bank 1 check: Not complete
ECU status: Learnt
ECU status: Unlock
Bypass passed: No
Password: Not programmed
Immobilizer signal: Connected
Fast start: Permit
Fuel pump relay: Off
Brake pedal switch 2: Off
Clutch pedal switch: Not pressed
A/C request: No
A/C relay: Off
A/C pressure: Normal
Cooling fan relay 1: Off
Cooling fan relay 2: Off
Idle speed: On
Power enrichment: Off
Evaporative emission (EVAP) system, canister purge valve: Off
O2 sensor 1, bank 1: Not ready
O2 sensor 1, bank 1 loop control: Open Loop
O2 sensor 2, bank 1: Not ready
O2 sensor 2, bank 1 loop control: Open Loop
Air/fuel adaptation: Off
Fuel cut-off: Off
Knock control: Off
Dynamic counter not equal to zero: No
Misfire detection: Off
Rough road: No
Brake pedal switch 1: Off
Functionality registration control active: Yes
Check engine telltale: On
Engine running time: 3900 min
ROM checksum : FB32
ABS: Present
ESP: Not present
Automatic transmission: Not present
Body control module: Present
Cruise control: Not present
Shift lock solenoid: Off
Intake manifold tuning (IMT) system, valve: Off
Air flow circulation (MAP): 550.0 mg/cyc
MAP sensor: 1214.8 mbar
Irregular rotation adaptation (range 1): -0.093425 °
Irregular rotation adaptation (range 2): -0.093425 °
Irregular rotation adaptation (range 3): -0.093425 °
Irregular rotation adaptation (range 4): -0.093425 °
Misfire cylinder 1: 0
Misfire cylinder 2: 0
Misfire cylinder 3: 0
Misfire cylinder 4: 185
Total number of misfire: 1615
Misfire recognition disable (RPM < MIN): No
Misfire recognition disable (RPM > MAX): No
Misfire recognition disable (Increase load): No
Misfire recognition disable (Increase RPM): No
Misfire recognition disable (Load lower than threshold): No
Fuel cut-off: No
Misfire monitoring: Enable
Irregular rotation adaptation (range 1): Complete
Irregular rotation adaptation (range 2): Not complete
Irregular rotation adaptation (range 3): Not complete
Irregular rotation adaptation (range 4): Not complete
Misfire, cylinder 1 in drive cycle: 0
Misfire, cylinder 2 in drive cycle: 0
Misfire, cylinder 3 in drive cycle: 0
Misfire, cylinder 4 in drive cycle: 0
Battery voltage (ADC): 14.32 V
Engine coolant temperature (ADC): 0.703 V
Intake air temperature sensor (ADC): 3.964 V
Intake manifold pressure (MAP) (ADC): 15.298 V
Throttle position sensor 1 (ADC): 0.640 V
Throttle position sensor 2 (ADC): 4.360 V
Accelerator pedal position sensor 1 (ADC): 0.761 V
Accelerator pedal position sensor 2 (ADC): 0.371 V
O2 sensor 1, bank 1 (ADC): 0.025 V
O2 sensor 1, bank 1: 2.0 Ohm
O2 sensor 2, bank 1 (ADC): 0.025 V
O2 sensor 2, bank 1: 0.0 Ohm
Knock sensor (ADC): 0.313 V
Cooling fan: 0.000 V
Generator load signal: 100
Generator L signal: No
Oil pressure switch: No
Cruise control "Set" switch: No
Cruise control active: No
Freon pressure sensor (ADC): 0.000 V
Knock signal cylinder 1: 0.237 V
Knock signal cylinder 2: 0.320 V
Knock signal cylinder 3: 0.412 V
Knock signal cylinder 4: 0.252 V
Knock retard angle cylinder 1: 0.0 °
Knock retard angle cylinder 2: 0.0 °
Knock retard angle cylinder 3: 0.0 °
Knock retard angle cylinder 4: 0.0 °
Ignition angle retardation: 34.5 °
Maximum ignition angle: 179.2 °
CO correction: --
Service records
VIN no:
Vehicle manufacture date:
Repair shop code or tester serial number:
Engine ID: !
Odometer: 227272294 km
Fuel consumption: 0.0 L
Working time: 0 min
Temperature threshold: 0 sec
Knock control (B1): 0 min
Engine start: 0 Counts
Engine start successful: 0 Counts
RPM threshold: 0 min
Превышение скорости в период обкатки 1: 4626 min
Превышение скорости в период обкатки 2: 18.1 min
Time since vehicle speed sensor fault: 0 min
Отключение постоянного питания контроллера: 0 Counts
Misfire: 0 min
Knocking: 1 min
Отказ датчика O2: 0 min
Time since check engine telltale on: 0 min
Service record: Data records in control module changed
Actuators test
Controls
Injectors
Ignition coil
Fuel pump relay
Cooling fan relay 1
Cooling fan relay 2
A/C compressor relay
Starter relay
Check engine telltale
Idle rpm control
Evaporative emission (EVAP) system, canister purge valve
CO correction
Intake manifold runner control valve
Shift lock solenoid
Utility
Controls
ECU Reset
ECU learn reset
Electronic control units pairing