Car, LADA, 2110x-2112x, 2111 (1.5 L SOHC) - Bosch 1.5.4 Janvar 5.1.x (PCM)

VIN no:

Hardware number: 21ipTuningVAZ

ECU no: NERABOCHIE

Software number: DMRV VAZ

System: t.8-916-2916848

Part number:

Software date: KUPLYU

Software ID: J5V17X17

ROM checksum : FF 00

Body number: 1111111

Engine number: 2222222

Manufacture date: 3333333333

P0338: Crankshaft position sensor - circuit open

P0102: Mass or volume air flow (MAF) sensor - circuit low voltage

Clear DTC

Engine status: Run

Knocking zone: No

Idle speed: Yes

Evaporative emission (EVAP) system, canister purge valve: Closed

Power enrichment: No

Fuel cut-off: No

Previous canister purge valve: Open

Require param idle: Yes

Knocking: No

Previous idle speed: Yes

Previous idle speed block: Yes

Previous knocking zone: No

Engine coolant temperature sensor: 90 °C

Idle speed CO correction: 0.000

Throttle position sensor: 0 %

Engine speed: 3000 rpm

Idle speed: 2550 rpm

Target idle speed actuator: 120 steps

Idle speed actuator: 120 steps

Time injection correction coefficient: 1.000

Ignition advance angle: 18.0 °

Vehicle speed sensor: 0 km/h

Battery voltage: 12.10 V

Target idle speed: 1400 rpm

Injection time bank 1: 1.60 ms

Mass air flow sensor: 10.0 kg/h

Air flow circulation: 41.3 mg/cyc

Fuel consumption: 0.0 L/h

Fuel consumption: 512.0 L/100km

Knock sensor (ADC): 0.000 V

Engine coolant temperature (ADC): 3.554 V

Mass air flow sensor (ADC): 0.996 V

Battery voltage (ADC): 12.144 V

CO potentiometer (ADC): 1.245 V

Throttle position sensor (ADC): 0.488 V

Irregular rotation adaptation: 0.007000

Reset counter (range 2): 400.0

Reset counter (range 3): 16.0

Reset counter (range 4): 400.0

Irregular rotation adaptation (range 1): 1.000000

Irregular rotation adaptation (range 2): 1.000000

Irregular rotation adaptation (range 3): 1.000000

Irregular rotation adaptation (range 4): 1.000000

Misfire cylinder 2: 2

Misfire cylinder 4: 4

Misfire cylinder 3: 3

Misfire cylinder 1: 1

Misfire recognition disable (Load lower than threshold): No

Misfire recognition disable (RPM < MIN): No

Misfire recognition disable (Fuel cut-off): No

Misfire recognition disable (RPM > MAX): No

Misfire recognition disable (Increase load): No

Misfire recognition: Disable

Misfire recognition disable (Increase RPM): No

Immobilizer status: 0F

Immobilizer signal: Communication ok

Start: Start allowed

ECU learning: Allowed

Immobilizer: Not active

Hardware ID: FF FF

Intake air temperature sensor: Enable

O2 sensor 1, bank 1: Enable

Camshaft sensor: Enable

Evaporative emission (EVAP) system, canister purge valve: Enable

EGR valve: Enable

Knock sensor: Enable

Vehicle speed sensor: Enable

CO potentiometer: Enable

Synchronous fuel injection: Enable

Throttle position sensor adaptation (close): Enable

Async start fuel injection: Enable

Save error: Enable

Check engine telltale

Fuel pump relay

Cooling fan relay 1

Cooling fan relay 2

A/C relay

Injectors

Ignition coil cylinder 1+4

Ignition coil cylinder 2+3

CO correction

Idle speed actuator

Idle rpm control

Edit VIN

ECU Reset

Edit body number

Edit engine number

Edit manufacture date

Edit part number