Car, LADA, 2108x-2109x, 2111 (1.5 L SOHC) - Bosch 1.5.4N Janvar 5.1 E2 (PCM)

VIN no:

Hardware number: 2112 -1411020-41

ECU no: NOTSUPPORT

Software number: 1411010-41

System: SAMARA-1.5L,16V

Part number:

Software date: 22-01-2002

Software ID: J5V05N35

ROM checksum : D1 4D

Body number:

Engine number:

Manufacture date:

P1610: Unknown DTC

Clear DTC

O2 sensor 1, bank 1 loop control: Closed Loop

Engine status: Run

Knocking zone: Yes

Idle speed: No

Evaporative emission (EVAP) system, canister purge valve: Open

Power enrichment: No

Save O2 adaptation: No

Fuel cut-off: Off

Previous canister purge valve: No

Require param idle: No

Knocking: No

Previous idle speed: No

Previous O2 sensor 1, bank 1: Lean

Previous idle speed block: Enable

O2 sensor 1, bank 1: Rich

Previous knocking zone: Yes

Engine coolant temperature sensor: 95 °C

Air/Fuel ratio: 14.7

Throttle position sensor: 21 %

Engine speed: 1160 rpm

Idle speed: 1180 rpm

Target idle speed actuator: 70 steps

Idle speed actuator: 70 steps

Time injection correction coefficient: 1.000

Ignition advance angle: 23.0 °

Vehicle speed sensor: 0 km/h

Battery voltage: 11.95 V

Target idle speed: 1600 rpm

O2 sensor 1, bank 1: 0.449 V

O2 sensor 1, bank 1: Not ready

O2 sensor 1, bank 1 heater: Disable

Injection time bank 1: 4.28 ms

Mass air flow sensor: 25.0 kg/h

Air flow circulation: 178.0 mg/cyc

Fuel consumption: 2.2 L/h

Fuel consumption: 512.0 L/100km

Knock sensor (ADC): 0.000 V

Engine coolant temperature (ADC): 1.348 V

Mass air flow sensor (ADC): 1.387 V

O2 sensor 1, bank 1 (ADC): 0.566 V

Throttle position sensor (ADC): 0.430 V

Irregular rotation adaptation: 0.007000

Reset counter (range 2): 400.0

Reset counter (range 3): 16.0

Reset counter (range 4): 400.0

Irregular rotation adaptation (range 1): 1.000000

Irregular rotation adaptation (range 2): 1.000000

Irregular rotation adaptation (range 3): 1.000000

Irregular rotation adaptation (range 4): 1.000000

Misfire cylinder 2: 2

Misfire cylinder 4: 4

Misfire cylinder 3: 3

Misfire cylinder 1: 1

Misfire recognition disable (Load lower than threshold): No

Misfire recognition disable (RPM < MIN): No

Misfire recognition disable (Fuel cut-off): No

Misfire recognition disable (RPM > MAX): No

Misfire recognition disable (Increase load): No

Misfire recognition: Enable

Misfire recognition disable (Increase RPM): No

Immobilizer status: FE

Immobilizer signal: Communication error

Start: Start allowed

ECU learning: Allowed

Immobilizer: Active

Hardware ID: D3 00

Intake air temperature sensor: Disable

O2 sensor 1, bank 1: Disable

Camshaft sensor: Disable

Evaporative emission (EVAP) system, canister purge valve: Disable

Fuel cut-off: Enable

EGR valve: Disable

Idle speed adaptation: Disable

Knock sensor: Disable

Vehicle speed sensor: Disable

CO potentiometer: Disable

Synchronous fuel injection: Enable

Throttle position sensor adaptation (close): Disable

Asynchronous injection during acceleration: Disable

Async start fuel injection: Disable

Save error: Disable

A/C relay

Injectors

Check engine telltale

Cooling fan relay

Fuel pump relay

Ignition coil cylinder 1+4

Ignition coil cylinder 2+3

Idle rpm control

Idle speed actuator

CO correction

Edit VIN

ECU Reset

Edit body number

Edit engine number

Edit manufacture date

Edit part number