Car, SUBARU, PLEO, ABS, VDC
Brake system - ABS/VDC - 0
Identification
Identifier: BB 0C 04
System: VDC
DTC
C1532: BLS on malfunction
C1811: System failure
U0100: Lost communication with engine/power control module (ECM/PCM) "A"
U0101: Lost communication with TCM
Controls
Clear DTC
DTC
P0055: Unknown DTC
P0058: Unknown DTC
P00C1: Unknown DTC
Controls
Clear DTC
Data stream
Trip count: 11496 times
Count: Common
Time counter 1: 245300 ms
Right front wheel speed sensor: 0.0 km/h
Left front wheel speed sensor: 0.0 km/h
Right rear wheel speed sensor: 0.0 km/h
Left rear wheel speed sensor: 0.0 km/h
Steering wheel angle sensor: -9 °
Yaw rate sensor: 0.0 °/sec
Pressure sensor: 48.4 bar
Longitudinal acceleration sensor: 0.0 m/s²
Lateral acceleration sensor: 0.0 m/s²
Ignition voltage: 12.56 V
Motor relay monitor: 0.00 V
Left front wheel cylinder pressure sensor output: -16369.0 bar
Right front wheel cylinder pressure sensor output: 12288.0 bar
Motor relay signal: Off
Valve relay signal: Off
EBD telltale: Off
ABS telltale: On
VDC warning light: On
EBD control: Off
ABS control: Off
TCS control: Off
VDC control: Off
E/G control stop flag: 1
Stop lamp relay drive signal: On
X mode: On
E/G torques up control stop flag: 1
HEV control stop flag: 1
HEV torques up control stop flag: 1
VDC off light: On
Off switch signal: Off
Brake light switch: Off
Clutch switch: Off
Reverse signal: Off
Utility
Controls
Steering angle sensor and Lateral acceleration sensor calibration
ABS sequence control mode