Car, SSANGYONG, Actyon sport II (Q150), D22DTR (ECM)
D22DTR (ECM) - 0
Identification
Part number:
VIN no:
Software version:
DTC
Controls
Clear DTC
Data stream
Barometric pressure sensor: 2.6 bar
Engine speed (Camshaft): 0 rpm
Ignition voltage: 25.50 V
Fuel temperature: 205 °C
Intake manifold pressure: 2.6 bar
Accelerator pedal position sensor 1: 100.0 %
Accelerator pedal position sensor 2: 100.0 %
Accelerator pedal position: 100.0 %
Fuel rail pressure: 2550 bar
Coolant temperature: 205 °C
Air temperature: 205 °C
Mass air flow sensor: 510 g/sec
Mass air flow sensor: 2550 mg/strk
Vehicle speed: 255 km/h
Ignition switch: On
Gear ratio:
Odometer: 131070 km
A/C pressure: 40.8 bar
EGR valve feedback: 120.0 %
Throttle position sensor: 100.0 %
VGT actuator: 100.0 %
Catalyst diesel particulate filter (CDPF) differential pressure: 5100 mbar
Catalyst diesel particulate filter (CDPF) temperature after diesel oxidation catalyst (DOC): 1000 °C
Intake air temperature sensor: 1000 °C
Exhaust gas temperature before turbocharger: 1000 °C
Fuel tank level: 100.0 %
O2 sensor 1, bank 1: On
O2 sensor 2, bank 1: On
O2 sensor 1, bank 1 heater: On
O2 sensor 2, bank 1 heater: On
Ambient air temperature: 205 °C
Lambda value: 10.0
VGT position: 100.0 %
Target injection quantity: 25.5 mg/strk
Engine speed (Crankshaft): 8160 rpm
Indicated actual torque: 920 N·m
OBD maximum indicated torque: 920 N·m
Boost pressure demand: 5.1 bar
Target fuel rail pressure: 2550 bar
VGT duty cycle: 155 %
EGR valve duty cycle: 155 %
Electronic throttle control (ETC) motor duty: 155 %
Swirl flap - duty cycle: 155 %
EGR valve, target position: 100.0 %
Inlet meeting valve (IMV) current: 2550 mA
Engine state: STALLING
Catalyst diesel particulate filter (CDPF) soot load: 255 %
O2 sensor 1, bank 1 heater duty cycle: 100.0 %
Clutch switch:
Brake light switch: On
Brake safety switch: On
Brake pedal switch: On
A/C switch: On
Power supply relay: On
Glow plug: On
Cruise control "Off" switch: On
Cruise control neutral condition: On
Cruise control "Accelerate" switch: On
Cruise control "Decelerate" switch: On
Cruise control "Resume" switch: On
Catalyst diesel particulate filter (CDPF) regeneration mode: DOC light off
VGT duty cycle: 100.0 %
Target throttle position: 155 %
Battery voltage: 25.50 V
O2 sensor 1, bank 1: 7.969 V
Engine load: 100.0 %
Engine running time: 65535 sec
Sulfur mass: 4294967295 mg
O2 sensor 2, bank 1 heater duty cycle: 100.0 %
O2 sensor 2, bank 1: 7.969 V
Actuators test
Controls
Cooling fan low speed
Cooling fan high speed
Throttle valve actuator
VGT actuator
EGR valve control
Swirl flap
Glow plug control
A/C relay
EGR cooler bypass valve
Fuel pump control
Starter relay
Variable oil pump
PTC heater 1
PTC heater 2
Immobilizer telltale
Fuel filter telltale
Check engine telltale
Oil pressure telltale
Battery charge telltale
Glow indicator
Cruise control telltale
GSI telltale
Generator check
Injectors
Utility
Controls
Edit VIN
Injectors replacement
Electronic throttle learning
Main relay
EGR valve learning
Reset swirl flap adaptation
Swirl flap learning
Reset VGT adaptation
Reset accelerator pedal position adaptation
Reset mass air flow sensor learned values
Load speed learning
RPC adaptation reset
A/F sensor 1 bank 1 adaptation reset
A/F sensor 2 bank 1 adaptation reset
DPF regeneration (while driving)
DPF regeneration (vehicle stationary)
DPF replacement
A/F sensor 1 bank 1 cleaning
A/F sensor 2 bank 1 cleaning
Fuel rail pressure sensor replacement
LNT (Lean Nox Trap) replacement
LNT desulfurization
Particulate matter sensor regeneration (Idle)
Injector tip leak test
Hydraulic test
IMV test
Fuel rail pressure test
Injector correction
Replace ECU
Configuration
Controls
Edit configuration