Car, SSANGYONG, Rexton II (Y250), G28D MSE (ECM)

Part number: 16 25 53 07 02

Software version: 06 51

Manufacture date: F0 12 31

Sequence number: 10 1F

Software ID: SH59429$

P0135 [2]: O2 sensor 1, bank 1 heater - circuit short to ground

P0155 [2]: O2 sensor 1, bank 2 heater - circuit short to ground

P0012 [0]: Camshaft position maximum angular variation in retarded direction

Clear DTC

Engine coolant temperature: 86.0 °C

Intake air temperature: 70.0 °C

Engine rpm: 0 rpm

Engine speed (fine): 750 rpm

Engine load: 0.0 %

Mass air flow sensor: 6553.5 kg/h

Throttle position sensor: 5.5 %

Ignition advance angle: 0.0 °

Indicated engine torque: 0.0 N·m

Injection time: 0.0 ms

Battery voltage: 11.78 V

Front axle speed: 306.0 km/h

Rear axle speed: 1024.0 km/h

Accelerator pedal position sensor 1: 0.49 V

Accelerator pedal position sensor 2: 0.24 V

Throttle position sensor 1: 0.72 V

Throttle position sensor 2: 4.26 V

O2 sensor 1, bank 1: 499.6 mV

Idle speed position switch: On

Full load: Off

Shift gear state (A/T): On

A/C control: Off

Clutch switch (M/T only): Off

Camshaft actuator: Off

Knocking control: Off

Protect mission: Off

Canister purge valve test: Off

Lambda control: Off

Catalyst heating: On

Overspeed fuel cut-off: Off

Fuel cut-off: Off

Brake switch: Off

Target idle speed (P-N): 0 rpm

Target idle speed (R-D-3-2-1): 0 rpm

Fuel integrator 1: 1.000

Fuel integrator 2: 1.999

Misfire cylinder 5: 65535

Misfire cylinder 6: 65535

Misfire cylinder 1: 65535

Misfire cylinder 2: 65535

Misfire cylinder 3: 65535

Misfire cylinder 4: 65535

Fuel tank level: 17

Fuel pump relay

Intake manifold tuning (IMT) system, valve

Camshaft

Injectors

A/C fan relay

Canister purge valve test

A/C clutch

Secondary air pump

ECU Reset

EVAP leak test

Fingerprint check

Secondary air pump

Flywheel adaptation

Edit configuration

Edit vehicle configuration