Car, SSANGYONG, Rexton G4 (Y400), G20DTR (ECM)
G20DTR (ECM) - 0
Identification
Part number: --
VIN no: qwertyuiopasdfghg
DTC
Controls
Clear DTC
Data stream
Drive position: D
A/C switch: On
A/C compressor status: Yes
Condition Fuel Cut Off: Yes
Throttle position at idle position: Yes
Throttle wide open position: Yes
Ignition status: On
Fuel pump control: On
Main relay status: On
Clutch switch: Open
Brake pedal switch: Pressed
Camshaft control: Enabled
Engine running detected: Yes
Battery voltage: 25.5 V
Intake manifold pressure: -- hPa
Throttle position sensor: -- %
Accelerator pedal position sensor signal: -- %
Engine coolant temperature sensor: -- °C
Coolant temperature at engine start: -- °C
PWM: -- %
Intake air temperature: -- °C
Engine oil temperature: -- °C
Ambient temperature: -- °C
Ambient pressure: -- hPa
Gear engaged: --
A/C pressure: -- hPa
Vehicle speed: -- km/h
O2 sensor 2, bank 1: -- V
O2 sensor correction: --
Fuel adaptation, idle active, bank 1: -- %
Fuel adaption (part load): --
Target air/fuel ratio: --
Purge control valve duty: -- %
Ignition 1 output: -- kW
Ignition 2 output: -- kW
Ignition 3 output: -- kW
Injection timing of all cylinders: -- ms
Engine speed: -- rpm
Target idle speed: -- rpm
Engine load: -- %
Engine running time: -- min
Fuel consumption: -- ms
Turbocharger boost control solenoid valve feedback: 80.00 V
System voltage: 25.5 V
CAN transmit error counter (TEC): 255
CAN receive error counter (REC): --
CAN-bus OFF counter: --
Cruise control main switch: On
Cruise control/speed limiter: status of the "Cancel/Resume" button: On
Cruise control "Set" button: On
Cruise control "Plus" button: On
Cruise control "Minus" button: On
Cruise control "Acceleration" button: On
Cruise control "Deceleration" button: On
Cruise control "Resume" button: On
State of cruise control or speedlimiter:
Actuators test
Controls
Check engine telltale
A/C compressor relay
Fuel open loop
Canister purge valve
ETC Motor
Ignition coil, cylinder 1
Ignition coil, cylinder 2
Ignition coil, cylinder 3
Ignition coil, cylinder 4
Disable fuel injection 1
Disable fuel injection 2
Disable fuel injection 3
Disable fuel injection 4
Intake oil control valve
Exhaust oil control valve
Turbocharger actuator position
Utility
Controls
Edit VIN
ECU registration
Auto detection trigger
Configuration
Controls
Edit configuration
Configuration
Controls
Edit parameter configuration