Car, RENAULT, THALIA , SYMBOL, K9K - Diesel (INJ)
K9K - Diesel (INJ) - 0
Identification
Electronic version: 32 35 37 35 52
Program number: 34 D3
Software version: 45 00
Calibration number: 43 80
MPR reference: 34 30 33 34 52
Diagnostic version: 44
Supplier: 153
VIN no: X7LHSRDVN51262429
DTC
DF092 [CO]: O2 sensor 1, bank 1 - circuit open
Controls
Clear DTC
Data stream
Idle speed reference: 0 rpm
Vehicle speed: 0 km/h
Ignition advance angle: -24 °CRK
Knock correction: 0 °CRK
Engine coolant temperature sensor: -- °C
Intake air temperature sensor: -40 °C
MAP sensor: 103 mbar
Engine speed: 0 rpm
Computer + after ignition: Missing
Pedal no load and throttle closed: No
Check engine telltale request from transmission control module: No
Actuator relay control: Inactive
Fuel pump relay command: Inactive
Canister purge control: Inactive
O2 sensor 1, bank 1 heater: Inactive
O2 sensor 2, bank 1 heater: Inactive
Accelerator pedal position: -- %
Accelerator pedal position sensor 1: -- V
Accelerator pedal position sensor 2: -- V
No load position programming value: -- %
Mass or volume air flow sensor estimated value: -- kg/h
Electronic throttle control (ETC) throttle position 1 upper stop: -- V
Electronic throttle control (ETC) throttle position 2 upper stop: -- V
Electronic throttle control (ETC) throttle position 1 lower stop: -- V
Electronic throttle control (ETC) throttle position 2 lower stop: -- V
Throttle lower limit after offset applic.: -- %
Throttle position sensor: -- %
Electronic throttle control (ETC) position corrected value : -- %
Electronic throttle control (ETC) corrected position setting: -- %
Accelerator pedal position sensor 1: -- %
Accelerator pedal position sensor 2: -- %
Throttle position sensor 1: -- %
Throttle position sensor 2: -- %
Throttle actuator at lower mechanical stop: -- %
Electronic throttle control (ETC) high stop programmed value: -- %
Throttle position sensor 1: -- V
Throttle position sensor 2: -- V
Richness autoadaptive offset: --
Richness autoadaptive gain: --
Theoretical idle regulation RCO: -- %
Richness correction: -- %
Injection time: -- ms
Canister bleed solenoid valve RCO: -- %
Idle regulation programming value: -- %
Average knock signal: --
O2 sensor 1, bank 1: -- mV
O2 sensor 2, bank 1: -- mV
Distance since check engine telltale on (OBDII): -- km
Flywheel target programming: --
Cylinder 1 recognition: --
Double richness loop : --
Idle rpm control: --
Programming throttle limits: --
Richness regulation: --
Flywheel signal: --
Immobilizer code programmed: No
Immobilizer: Inactive
Impact detected: Inactive
Refrigerant pressure: -- bar
A/C authorisation: --
A/C request: --
Accelerated idle request: --
Air conditioner: --
Cooling fan high speed request: --
Cooling fan low speed request: --
Number of PC heating resis. fixed: --
RCH CUT-OUT: --
Power absorbed by the A/C compressor: -- W
Starting: --
Motor: --
Brake pedal switch 2: --
Cruise control setting: -- km/h
Brake pedal switch 1: --
Configuration
AC air heater resistor management: --
Traction control: --
O2 sensor 1, bank 1: --
O2 sensor 2, bank 1: --
OBD warning light control: --
Vehicle transmission type: --
Vehicle speed connection type: --
Air conditioner: --
Actuators test
Controls
Fuel pump relay
Electronic throttle control (ETC)
Evaporative emission (EVAP) system, canister purge valve
O2 sensor 1, bank 1 heating
O2 sensor 2, bank 1 heating
Static test of actuators
Utility
Controls
V010 Edit VIN
V013 Injector control lock
V008 Injector control unlock
R005 Programmed values