Car, PEUGEOT, 206+, 9HY - Bosch EDC 16C3 E4
9HY - Bosch EDC 16C3 E4 - 0
Identification
PSA reference: 00 00 00 00 00
ECU manufacturer: Siemens
Additional number: 96 57 99 97 80
Diagnostic version: FF
Calibration version: FF FF
Software version: 2A 01
Emission: Not defined
ECU production date: --
Software reference: 00 00 00
DTC
P0203: Injector cylinder 3 circuit *2 open
Controls
Clear DTC
Data stream
Intake air temperature sensor: 35.3 °C
Inlet air temperature at manifold: 87.5 °C
Learn status: 0; 0; 0; 0; 0; ; ;
Barometric pressure sensor: 1.000 bar
Measured turbo pressure: 2.059 bar
Vehicle speed sensor: 0 km/h
Clutch pedal: Pressed
Gear transmission ratio:
Fuel temperature sensor: 13.8 °C
Cooling fan circuit pressure: 10.4 bar
Engine coolant temperature sensor: 62.6 °C
Cooling fan relay: No
Powertrain speed: 0.0 %
Cooling fan reference speed: 0.0 %
Battery voltage: 11.44 V
Ignition voltage: 9.60 V
Camshaft and crankshaft synchronization:
Fuel flow regulator: 82.0 %
Diesel output delivered by the pump reference value: 1231.4 mm³/s
Target mass air flow: 223.5 mg/impulse
Brake pedal switch: Pressed
EGR throttle electrovalve open cycle ratio: 62.7 %
Pre-post heating relay: Active
Engine speed: 7453.1 rpm
Fuel pressure sensor: 1772.5 bar
Accelerator pedal position sensor: 94.1 %
Injected flow measured: 94.5 mg/impulse
Mass air flow sensor: 1276.5 mg/impulse
Injector control error status:
Injector 1 correction value: -2.0 mg/impulse
Injector 4 correction value: -6.0 mg/impulse
Injector 2 correction value: 0.1 mg/impulse
Injector 3 correction value: -2.0 mg/impulse
Turbo pressure: 0.388 bar
Turbo pressure duty cycle: 0.0 %
Bypass throttle solenoid valve open cycle ratio: 92.9 %
EGR throttle electrovalve open cycle ratio: 87.5 rpm
Catalytic converter downstream temperature: 0.0 °C
Exhaust gas differential pressure: 0.0 mbar
Intake air temperature sensor: 200 °C
Diesel Particulate filter (DPF) load state: 96.1 %
Average distance between the last 5 regenerations: 6420.0 km
Diesel Particulate filter (DPF) distance since last regeneration: 5418.5 km
Bypass flap position repeat (if present): 13.7 %
EGR throttle position: 11.0 %
Weight of additive in the PEF: 13.7 g
Volume of additive remaining in the reservoir: 175 ml
Immobilizer
Locking of the ECU: Locked
Immobilizer status: Matched ECU
Problem detected when transmitting the unlock code: BSI response incorrect
Actuators test
Controls
Cooling fan high speed
Additional heating relay
Cooling fan low speed
Pre-post heating relay control
EGR valve
EGR throttle
Fuel flow regulator
Utility
Controls
Injectors replacement
EGR valve change
Air mixer change