Car, PEUGEOT, 206, 8HX - EDC16C3

PSA reference: 96 47 78 55 80

ECU manufacturer: Valeo

Additional number: 96 44 09 83 80

Diagnostic version: FF

Calibration version: FF FF

Software version: B0 03

Emission: Not defined

ECU production date: --

Software reference: 00 00 00

P0704: Clutch switch signal no signal or signal not range/performance

Clear DTC

Inlet air temperature at manifold: 0.0 °C

Barometric pressure sensor: 0.000 bar

Turbo pressure: 0.000 bar

Vehicle speed sensor: 0 km/h

Clutch pedal: Pressed

Gear engaged: Neutral

Fuel temperature sensor: -40.0 °C

Engine coolant temperature sensor: 202.0 °C

Intake air temperature sensor: 87.5 °C

Engine speed: 7870.7 rpm

Battery voltage: 25.60 V

Camshaft and crankshaft synchronization:

Fuel flow regulator: 33.3 %

Diesel output delivered by the pump reference value: 23690.2 mm³/s

Target mass air flow: 960.8 mg/impulse

Brake pedal: Pressed

Pre-post heating relay: 175

Fuel pressure measured: 0.0 bar

Accelerator pedal position sensor: 0.0 %

Mass air flow sensor: 0.0 mg/impulse

Mass air flow sensor: 0.0 mg/impulse

Injectors 1/4: 0

Injectors 2/3: 0

Injector 1 correction value: -6.0 mg/impulse

Injector 3 correction value: -6.0 mg/impulse

Injector 4 correction value: -6.0 mg/impulse

Injector 2 correction value: -6.0 mg/impulse

Reference fuel pressure: 0.0 bar

EGR throttle electrovalve open cycle ratio: 0.0 %

EGR solenoid valve: 0.0 %

Locking of the ECU: Locked

Immobilizer status: Matched ECU

Problem detected when transmitting the unlock code: The programming status of the engine immobiliser cannot be read

Cooling fan high speed

Cooling fan low speed

Additional heating relay

Preheating relay

EGR valve

Diesel pressure regulation

Injectors replacement