Car, PEUGEOT, 407, 6FZ - Sagem S2000PM2 VAN

PSA reference: 96 36 76 05 80

ECU manufacturer: Valeo

Additional number: 96 44 09 83 80

Diagnostic version: FF

Calibration version: FF FF

Software version: C1 00

Emission: If EURO4

ECU production date: --

Software reference: 63 65 52

P2101: Electronic throttle control (ETC) motor - circuit range/performance

P1340: Misfire detected, cylinder 4

P1631: Injection ECU internal fault

Clear DTC

Engine speed: 1184.0 rpm

Battery voltage: 14.30 V

Injection time bank 1: 4.9 ms

Deceleration fuel cut-off: No

Throttle position sensor: Idle

Throttle position sensor: 14.4 °

Throttle position sensor: 0.704 V

Engine coolant temperature sensor: 77.0 °C

Intake air temperature sensor: 11.0 °C

MAP sensor: 440.5 mbar

Evaporative emission (EVAP) system, canister purge valve: Inactive

Ignition angle: 22.1 °

Coil 1,4 dwell time: 2.5 ms

Coil 2,3 dwell time: 2.5 ms

O2 sensor 1, bank 1: Inactive

O2 sensor 2, bank 1: Inactive

O2 sensor 1, bank 1: 0.410 V

O2 sensor 2, bank 1: 0.468 V

Richness regulation: Open Loop

Engine coolant temperature sensor: 77.0 °C

Evaporative emission (EVAP) system, canister purge valve: 0.0 %

A/C relay: No

A/C request: No

Engine oil temperature sensor: 61 %

A/C pressure sensor: 1.312 bar

Engine torque: 33.4 N·m

Power supply relay: Active

Vehicle speed sensor: 0 km/h

Gear transmission ratio: N

Cooling fan relay: Active

Powertrain speed: 0.0 %

Cooling fan speed: 0.0 %

Locking of the ECU:

Immobilizer status:

Problem detected when transmitting the unlock code:

Injector 1

Injector 2

Injector 3

Injector 4

Fuel pump relay

Ignition coil cylinder 1+4

Ignition coil cylinder 2+3

Cooling fan high speed

Cooling fan low speed

Evaporative emission (EVAP) system, canister purge valve

EGR valve

O2 sensor 1, bank 1 heater

O2 sensor 2, bank 1 heater

A/C relay

Secondary air injection system relay

Electronic throttle control (ETC)

ECU learn reset