Car, OPEL, Astra G, 2002, Y17DT - HDRC (1)

VIN no: W0L0TGF7018056742

Repair shop code or tester serial number: DELCOLVPL3

Programming date: 20 00 11 17

Hardware number: DEL 0113386350

Part number alpha code: 97240621 EA

Software number: DLNF

Software version: 2

Existing ECU type approval no: D01008

System: Y17DT

Identifier: 13 05

Vehicle manufacturer specific: STRCB0A

P1631 [C]: Spill valve relay stuck open

Clear DTC

A/C coding: Detected

Cooling fan relay 1: Off

Cooling fan relay 2: Off

Ignition status: Off

Power supply relay: Off

Engine oil pressure: Low pressure

Spill valve relay: Off

Vehicle speed pulse: Not received

Accelerator pedal position at idle position: Not active

Simulate idle speed position switch: Not active

Glow time telltale: Off

Glow time relay: Off

Diagnosis glow time relay: Not active

Telltale (Check light): Off

A/C relay: Off

A/C information switch: Off

Brake pedal switch 1: Off

Clutch pedal switch: Off

Cruise control tip switch: Not active

Brake pedal switch 2: Off

Battery voltage: 0 V

Engine speed: 0 rpm

Pump speed: 0 rpm

Target idle speed: 0 rpm

Vehicle speed sensor: 0 km/h

Engine coolant temperature sensor: 0.00 V

Engine coolant temperature sensor: -40 °C

Intake air temperature sensor: 0.00 V

Intake air temperature sensor: -40 °C

Outside air temperature: -40 °C

Mass air flow sensor: 0.00 V

Mass air flow sensor: 0 kg/h

Boost pressure sensor: 0.00 V

Boost pressure sensor: 0 kPa

Boost pressure command: 0 kPa

Boost pressure solenoid valve - duty cycle: 0 %

Accelerator pedal position sensor 1: 0.00 V

Accelerator pedal position sensor 2: 0.00 V

Accelerator pedal position sensor: 0 %

EGR valve: 0 %

A/C pressure sensor: 0 V

A/C pressure sensor: 0 kPa

Fuel temperature sensor: -40 °C

Injection quantity: 0 mg/strk

Actual injection start: 0 °

Barometric pressure sensor: 0 V

Barometric pressure sensor: 0 kPa

Immobilizer function programmed: Yes

Security wait time: Not active

Cooling fan relay 1

Cooling fan relay 2

Edit configuration

Edit CAN configuration