Car, OPEL, Zafira B, 2013, A16XNT - A16XNT
A16XNT - A16XNT - 0
Identification
TPC ENG: FF
Software version: 34620302
VIN no: W0L0AHL4865174821
System identification: BOSCH0100
ECU software version number: 15922
Existing ECU type approval no: B06011
System: A16XNT
Hardware key number: 19FR2288
Identifier: 1D 04
Software version number: 34620302
Part number: 55558788
Hardware number: 61208396
Alpha code: BC
DTC
P1606 [1]: Replace electronic control unit (ECU)
P1481 [4]: Engine cooling fan control 1 - circuit open
P1230 [8]: Power supply relay - circuit malfunction
Controls
Clear DTC
Data stream
Cooling fan relay 1: On
Cooling fan relay 2: On
Cooling fan relay 3: On
Brake pedal switch 2: On
Clutch pedal switch: Active
Vehicle speed in cruise control range: Active
Cruise control tip switch: R (Resume)
Brake pedal switch 1: On
Cruise control: Active
A/C relay: On
A/C information switch: On
A/C cut-off mode: Engine temperature
Oil level: Normal
Engine oil level status: Warning
Engine oil life remaining: 127 %
Engine oil change warning: Active
Engine oil pressure: Low pressure
Ignition status: On
Power supply relay: Off
Fuel pump relay: On
Normal engine operating temperature: Not active
Starter relay: Not active
Vehicle speed pulse: Not received
Full load enrichment: Active
Throttle position sensor: Part load
Knock control (B1): Not active
Deceleration fuel cut-off: Active
O2 sensor 1, bank 1 loop control: Closed
Catalyst protection enrichment B1: Active
Evaporative emission (EVAP) system, canister purge valve: On
Air/Fuel ratio sensor 2, bank 1: Rich
O2 sensor 2, bank 1 heater: Active
Accelerator pedal position at idle position: Active
Idle speed modified: No
Check engine telltale: Flash
Service vehicle soon telltale: Flash
Non electronic throttle control (ETC) related limp home mode: Active
Electronic throttle control (ETC) limp home mode: Engine stalled
Battery voltage: 23.40 V
Engine speed: 0 rpm
Target idle speed: 1025 rpm
Acceleration sensor: 5 m/s²
Vehicle speed sensor: 0 km/h
Engine coolant temperature sensor: 0.14 V
Engine coolant temperature sensor: 210 °C
Intake air temperature sensor: 1.00 V
Intake air temperature sensor: 215 °C
Outside air temperature: 149 °C
A/C pressure sensor: 40 kPa
Mass air flow sensor: 0.02 V
Mass air flow sensor: 230 kg/h
Boost pressure sensor: 0.66 V
Boost pressure sensor: 24 kPa
Accelerator pedal position sensor 1: 4.57 V
Accelerator pedal position sensor 2: 0.00 V
Calculated accelerator pedal position: 32 %
Throttle position sensor 1: 0.14 V
Throttle position sensor 2: 4.88 V
Throttle position sensor 1 fully close learn: 0.41 V
Throttle position sensor 2 fully close learn: 2.04 V
Calculated throttle position: 74 %
Throttle position PWM servo signal: 100 %
Evaporative emission (EVAP) system, canister purge valve: 14 %
Knock sensor signal (B1): 40 V
Knock retard angle cylinder 1: 1 °
Knock retard angle cylinder 2: 24 °
Knock retard angle cylinder 3: 255 °
Knock retard angle cylinder 4: 35 °
Short term fuel trim bank 1: 83 %
O2 sensor 2, bank 1: 1.211 V
O2 sensor 1, bank 1: 0.000 V
Barometric pressure sensor: 0 kPa
Boost pressure command: 24 kPa
Boost pressure solenoid valve - duty cycle: 100 %
CNG tank pressure (Compressed Natural Gas): 1 bar
CNG line pressure: 1275 kPa
Requested fuel mode: CNG mode
Gasoline telltale: On
CNG relay: On
Cold start: Active
Engine overspeed event data
Overspeed events number: Counts
Overspeed function:
Immobilizer
Delivery mode: Active
Immobilizer function programmed: No
Free start mode: Not active
Security wait time: Active
Engine speed: 0 rpm
Target idle speed: 1025 rpm
Engine oil status
Remaining oil time: 1 %
Engine oil change warning (time): Not active
Remaining driving cycle: 24 %
Engine oil change warning (driving cycles): Not active
Remaining cold-start cycle: 127 %
Engine oil change warning (cold-start cycles): Active
Remaining distance: 35 %
Engine oil change warning (distance): Not active
Remaining crankshaft revolutions: 9 %
Engine oil change warning (Crankshaft revolutions): Not active
Engine oil life remaining: 34 %
Engine oil change warning: Not active
Actuators test
Controls
Fuel system switch LED test
Fuel pump relay
Ignition coil
Evaporative emission (EVAP) system, canister purge valve
A/C relay
Cooling fan relay 1
Cooling fan relay 2
Cooling fan relay 3
Cooling fan relay 4
CNG relay test
CNG tank valve relay test
CNG cutoff solenoid valve test
CNG pressure reducer solenoid valve test
Boost pressure valve
Turbocharger bypass solenoid
Electronic throttle control (ETC)
Utility
Controls
Reset O2 loop block learn map
Compression test
Edit tire circumference
Configuration
Controls
Edit configuration
Edit CAN configuration