Car, OPEL, Vectra B, 1999, X16SZR Vectra B - Multec (F)

VIN no: W0L000073V4375189

Repair shop code or tester serial number:

Programming date: FF FF FF FF

Hardware number: 16 25 09 10

Part number alpha code: 16214239 JS

Software number: CDJB

Software version: 4

Existing ECU type approval no: D96017

System: X14XE

Identifier: 01 04

P0200 [4]: Fuel injector - circuit malfunction

Clear DTC

MAP sensor: 1.05 bar

MAP sensor: 4.97 V

Battery voltage: 26 V

Intake air temperature sensor: 4.97 V

Intake air temperature sensor: 151 °C

Engine coolant temperature sensor: 4.97 V

Engine coolant temperature sensor: 151 °C

Ignition angle: 89 °

Engine load: 99 %

Knock cell number: 255

Knock retard angle cylinder 1: 89 °

Knock retard angle cylinder 2: 89 °

Knock retard angle cylinder 3: 89 °

Knock retard angle cylinder 4: 89 °

Throttle position sensor: 4.97 V

Throttle position sensor: 100 %

Vehicle speed sensor: 255 km/h

Engine speed: 6375 rpm

Injection time bank 1: 22 ms

Idle speed actuator: 255 steps

Target idle speed (P-N): 3187 rpm

Target idle speed (R-D-3-2-1): 3187 rpm

Target idle speed: 3187 rpm

O2 sensor 1, bank 1: 1.127 V

O2 integrator: 255 steps

O2 BLM cell number: 255

O2 BLM cell content: 255 steps

Evaporative emission (EVAP) system, canister purge valve: 100 %

Air/Fuel ratio: 26

EGR valve command: 99 %

EGR valve: 100 %

O2 sensor 1, bank 1 loop control: Closed

Full load enrichment: On

O2 sensor 1, bank 1: Rich

Deceleration fuel cut-off: On

O2 loop BLM enable: Active

Vehicle speed pulse: Received

Clear flood mode: Yes

Torque control: On

Blinkcode request: On

P/N switch: R-D-3-2-1 12V

IAC control: On

Fuel pump relay: On

A/C information switch: Active

A/C load signal: Active

Idle adjust: Modified

Idle adjust drive (R-D-3-2-1): Modified

A/C relay: On

Idle adjust P-N: Modified

Air control solenoid: On

O2 sensor 1, bank 1 heater: On

Secondary air injection system relay 1: On

Check engine telltale: On

Vehicle transmission type: A/T

Vehicle transmission type: A/T

Air conditioner: Present

Immobilizer: Active

Immobilizer signal: Received

Fuel pump relay

EGR valve

Evaporative emission (EVAP) system, canister purge valve

Idle speed actuator

A/C relay

Quad driver module

Injector circuit test

Air control solenoid

Secondary air injection system relay

Check engine telltale

Injectors

EGR Control

Idle rpm control

Adjust idle speed

Adjust idle speed P-N

Adjust idle speed drive

Reset Idle adjust

Reset Idle adjust

Reset knock learn map

Reset Idle speed actuator learn map

Reset O2 loop block learn map